Kohler KD 500 Instrukcja warsztatowa - Strona 38

Przeglądaj online lub pobierz pdf Instrukcja warsztatowa dla Silnik Kohler KD 500. Kohler KD 500 44 stron. 51267

Engine assembly

- 38 -

Mounting the injection pump on the engine

Lower the tappet in the innermost point of the engine by slightly

turning the flywheel.

- Insert a seal of adequate thickness (see section "Injection lead"

point 5, page 37).

- Turn the motor stop lever to the STOP position.

- Set the adjuster sleeve of the injection pump about one

millimeter from the stop position on the adjuster block (fig. 77).

- Fit the injection pump into the engine block and, keeping it

pressed down, fix it in place by tightening the nut that holds

the relative bracket. (Match the marks made during the

demounting phase, see section "Removing the injection pump"

page 17)

Warning: consult section "Braked engine test" page 39, if

the position of the injection pump in relation to the casing

was not marked during the demounting operations or if a

new one must be installed.

Mount the injector on the head, inserting the copper retention

seals (see section "Head" page 36).

Connect the injector to the pump with the injection pipe.

Warning: always use two wrenches to slacken off or

tighten injection pipes (fig. 78)

Workshop Manual KD500 _ cod. ED0053029390 - 1° ed_rev. 00