Aqua Flo AQUV-8 Instrukcja obsługi - Strona 11
Przeglądaj online lub pobierz pdf Instrukcja obsługi dla Systemy filtracji wody Aqua Flo AQUV-8. Aqua Flo AQUV-8 16 stron. Ultraviolet disinfection system
Drukuj stronę"A3" – LAMP EXPIRY: If the display shows "A3" alarm with red LED on and ballast beeps every 5 seconds, it indicates that the lamp has
expired. Do not consume water until lamp is replaced.
You can silence the alarm for 7 days by pressing and holding the button until "dELy" is displayed. You can silence the alarm 3 times
after which the alarm will not silence until you replace the UV lamp.
RESETTING THE LAMP EXPIRY TIMER: After replacing the UV lamp annually, you must re-set the ballast timer to clear the "A3"
alarm. To do this press and hold the button for approx 10 seconds until "rSET" is displayed. Release button and the ballast will emit a
long beep to confirm reset. Green LED will come on and red LED will turn OFF. Display will show "365" again.
(G) OPERATION AND MAINTENANCE
Your UV system is ON continuously during normal use and will continuously supply safe water. (Note: Do not try to shut it off during short periods of
non-use as repeated ON/OFF cycles can shorten the UV lamp and ballast life). Failure to follow disinfection procedure if the system is shut off could
result in micro-biologically unsafe water leading to potential illness or death.
To maintain the optimum disinfection performance of the UV system:
UV lamp should be replaced when the display reaches "0". At this point, the UV lamp continues to light but its ability to disinfect the water drops
below safe limits. Therefore the UV lamp MUST BE REPLACED WHEN THE LAMP REPLACEMENT ALARM "A3" COMES ON.
The quartz dome should be cleaned at the time of lamp replacement. If the water quality parameters listed in section 'C' are exceeded, you
should clean and inspect the quartz dome more frequently and clean as necessary.
Replace pre-filters every 4-6 months.
ITEM
UV Lamp
Quartz Dome
O-Rings
Use only GENUINE AQUA FLO AQUV UV Lamps with your UV system. Aqua Flo UV lamps are designed
with extensive product research and engineering to provide reliable and consistent UV output and
performance that ensures the safety of your drinking water. Using non-Aqua Flo AQUV UV lamps can
not only compromise the system performance but also voids your product warranty, electrical and CSA
•
Unsafe drinking water which may lead to illness and/or death
Use of non-Aqua Flo AQUV lamps will void all warranty & product certification
Aqua Flo logo & lamp part #
REPLACEMENT FREQUENCY
Every 1 year of use
Every 3 years
Annually
USE ONLY GENUINE AQUA FLO AQUV LAMPS
certification, and may result in any one or more of the following issues:
Genuine Aqua Flo AQUV lamps can be identified as follows:
CLEANING
At least during every annual lamp change. More
frequently if water is hard or has iron, manganese etc.
WARNING
•
Ballast failure
N/A
N/A
•
Electrical fire
11
Blue ends