AVPro Edge AC-EXO-444-KIT Skrócona instrukcja obsługi - Strona 2
Przeglądaj online lub pobierz pdf Skrócona instrukcja obsługi dla Przedłużacz AVPro Edge AC-EXO-444-KIT. AVPro Edge AC-EXO-444-KIT 4 stron. 4k hdmi extender via optical fiber; up to 2 kilometer
Drukuj stronęSetup of the Transmitter:
IR Mode Slide Switch: (On Front) This is used to select a
preferred IR Mode
There are two modes:
1. IR-EYE - The IR Input will be configured to operate with
an IR Receiver Eye (Default)
2. I-PASS – The IR Input will be configured to safely oper-
ate with a direct connection
from a control system using a mono or stereo 3.5mm
cable. It's protected @ 3v-20v.
Using the Setting Button: The setting button can be pressed in different combinations
based on what is needed. The status light on the front will flash based on the selection.
The selections are in series, meaning, for example, if you are on selection 5 you can come
back later and press it again to move you to 6, 7, 8, 1, 2, etc... The SETTING BUTTON is located
front of the transmitter next to the micro USB port. The indicator light is next to the
button.
Installation of the Extenders and connection order:
1)
Plug in the provided orange 2 pin power connector into both the
transmitter and receiver. Both must be powered for the system to func-
tion.
2)
Ensure the fiber is terminated with LC SFP connectors.
3)
The transmitter and receiver will have LC SFP ports. Plug the fiber
from the Transmitter to the Receiver.
4)
The Receiver has an HDMI output. Connect this to the input of the
display with an 18Gbps HDMI cable.
5)
The Transmitter has an HDMI input. Connect this to the output of
the source with an 18Gbps HDMI cable.
Connection Diagram
Fiber Optic
HDMI