AVR Cinema Mirror HC 37.53 Instrukcje i wskazówki dotyczące instalacji - Strona 6
Przeglądaj online lub pobierz pdf Instrukcje i wskazówki dotyczące instalacji dla Akcesoria do projektorów AVR Cinema Mirror HC 37.53. AVR Cinema Mirror HC 37.53 9 stron.
Drukuj stronęELECTRICAL CONNECTION
Connect a pushing-button (not included, of
1A 230 V.A.C.) to the supplied entrance
connector. Insert the connector of the
pushing-button in the Cinema Mirror.
Connect the power source cable to the
electric net and to protect with a bipolar
ELECTRIC CURRENT INPUT
PHASE
(L1) BROWN
EARTH ( )
YELLOW / GREEN
NEUTER (N)
BLUE
OPENING – CLOSING
BUTTON CONNECTION
INSTRUCTIONS AND TIPS FOR THE INSTALLATION
OF THE HC 37.53 MODEL CINEMA MIRROR
GENERAL RECOMMENDATIONS FOR ASSEMBLY AND INSTALLATION
NOW CINEMA MIRROR IS
READY TO BE INSTALLED
I N
T H E
INSTALLATION IN THE CEILING
6
Remove the plate that coincides with the
projector focal distance from the technical
ceiling and leave it aside for its use later on
the final finish of the ceiling.
If the ceiling is made of stucco, wood, glass
etc, install the HC 635 ceiling frame kit
beforehand; Four "T" profiles to be assembled
with its accessories so as to facilitate the
perfect decorative finish of the ceiling.
Insert the Cinema Mirror with the optic
mirrors facing the place where the projection
screen will be installed. Place the chassis onto
the "T" shaped profiles of the technical roof,
(or the HC 635 frame Kit ), and make coincide
the 2+2 leveling supports of the chassis
(Figure 3, detail 9) with the technical roof
profile.
IF THE INSTALLATION IS NOT EQUIPPED
WITH A WORKABLE TECHNICAL CEILING,
BUILD YOUR OWN SPACE USING THE
HC 635 MODEL CEILING FRAME KIT.
(see accessory page)
switch (not supplied) with separation among
contacts of 3 mm. (ELECTRIC DIAGRAM)
Connect the video, DVD, PC, control signals,
etc, following the instructions of the
videoprojector maker. Secure the cables with
flanges or plastic loops, (available in shops),
CLOSING SWITCH
C E I L I N G
Now the height of the chassis can vary and
can be levelled with the roof. To level them,
please unfasten the screws of the leveling
supports which holds the chassis and screed
the latter to the same height of the surface of
the roof. Fasten again and strongly the screws.
ATTENTION PLEASE! The motor system
(active door) is not prepared to carry heavy
loads, as for example, parts in wood, cork,
glass, etc., that one might want to install on
the door as decoration items.
If you desire this, try to modify the finish, by
painting or imitating the painting by means
of a very thin foil, to be able to integrate the
finish of the door of the Cinema Mirror to
the roof decoration in which it is installed.
Install the projector on the variable position
table.
· Place the projector optic as close to the
passive mirror as possible.
· Place the projector optic centred relative
to the passive mirror.
checking that they do not restrict the access
and movement of the chassis on the
technical ceiling "Ts" or supports. Move the
cables away from the area to facilitate the
later handling of the videoprojector: cleaning,
lamp replacement, etc.
OPENING SWITCH
IMPULS RELAY
MOTOR