Dell PowerEdge 2550 Instrukcja aktywacji - Strona 7

Przeglądaj online lub pobierz pdf Instrukcja aktywacji dla Serwer Dell PowerEdge 2550. Dell PowerEdge 2550 32 stron. Wake-on-lan (wol) support on dell servers
Również dla Dell PowerEdge 2550: Instrukcja instalacji (26 strony), Instrukcja instalacji (32 strony), Podręcznik konfiguracji (10 strony), Instrukcja instalacji stojaka (40 strony), Instrukcja instalacji (32 strony), Podręcznik (28 strony), Podręcznik (15 strony)

Drukuj stronę
Dell PowerEdge 2550 Instrukcja aktywacji
Connect the battery cable to the RAID battery connector on the system board
8
(see Figure 1-1).
Close the system doors, reconnect the system and peripherals to their electrical
9
outlets, and turn them on.
Enter the System Setup program and verify that the setting for the SCSI controller has
10
changed to reflect the presence of the RAID hardware.
See "Changing the System Setup Settings."
Install the RAID software.
11
For more information, see the RAID controller documentation.
Changing the System Setup Settings
Turn on your system.
1
If your system is already turned on, shut the system down and then turn it on again.
Press <F2> immediately after you see the following message:
2
Press <F2> for System Setup
If you wait too long and your operating system begins to load into memory, allow the
system to complete the load operation, and then shut down the system and try again.
NOTE: To ensure an orderly system shutdown, see the documentation that accompanied
your operating system.
Press <Alt><p> to switch to Page 2 of the System Setup screen.
3
•
If the system detects the new RAID controller memory module and RAID
hardware key, the system displays the RAID option in the Integrated Devices
section of the screen.
•
If the system displays the SCSI option, it did not detect the integrated RAID
controller. Ensure that the RAID hardware key and RAID memory module are the
correct type and repeat all hardware installation steps found earlier in this
document.
NOTICE: To avoid possible data loss, back up all data on the hard-disk drives before changing
the mode of operation of the integrated SCSI controller from SCSI to RAID.
A ct iv a ti n g th e De l l PE RC 3/D i
1-5