Guiding Signals
Projector
Status
Standby
Projector in Standby mode. Ready to
mode
power on.
Warming up
Projector takes some time to warm
mode
up and power on.
Lamp on
Projector in Normal mode, ready to
display an image.
accessed.
Cooling
Projector is cooling to shutdown.
mode
Projector
Air vents might be blocked or
overheated
ambient temperature may be above
40°C. The projector automatically
shuts down. Ensure that the air vents
are not blocked and that the ambient
temperature is within operational
range. If the problem persists,
contact Dell.
Fan
One of the fans has failed. The
breakdown
projector automatically shuts down.
If the problem persists, contact Dell.
Lamp driver
The lamp driver has failed. The
breakdown
projector automatically shuts down.
Unplug the power cord after three
minutes and then turn the display on
again. If this problem persists,
contact Dell.
Color Wheel
Color wheel cannot start. The
breakdown
projector has failed and the projector
automatically shuts down. Unplug
the power cord after three minutes
and then turn on the projector. If this
problem persists, contact Dell.
Lamp failure
Lamp is defective. Replace the lamp.
Fault - DC
Power supply has been interrupted.
supply (+12V)
The projector automatically shuts
down. Unplug the power cord after
three minutes and then turn on the
projector. If this problem persists,
contact Dell.
Lamp module
Lamp module connection may be
connection
disrupted. Check the lamp module
failed
and ensure that it is properly
installed. If the problem persists,
contact Dell.
Description
Note: The OSD menu is not
Control Buttons
TEMP
Power
(Amber)
White Flashing
White
White
White
OFF
AMBER
AMBER
OFF
Flashing
AMBER Flashing
AMBER
White
Flashing
OFF
AMBER Flashing
AMBER
OFF
Troubleshooting
Indicator
LAMP
(Amber)
OFF
OFF
OFF
OFF
OFF
OFF
OFF
OFF
OFF
OFF
AMBER
OFF
Flashing
AMBER
Flashing
OFF
AMBER
AMBER
AMBER
OFF
Flashing
21
Drukuj stronę