Dell Z9100-ON Instrukcja instalacji - Strona 37
Przeglądaj online lub pobierz pdf Instrukcja instalacji dla Przełącznik Dell Z9100-ON. Dell Z9100-ON 45 stron. Open networking
Również dla Dell Z9100-ON: Instrukcja instalacji (45 strony), Instrukcja instalacji (43 strony)
Drukuj stronę
4. Add a device to the file systems table (fstab) and mount the file systems—recommended.
ONIE:/ # vi /etc/fstab
# FSTAB entry for the ONIE-BOOT partition mounted on /boot
LABEL=ONIE-BOOT /mnt/onie-boot ext4
/dev/sdb
ONIE:/ # mount -a
Before you install an OS
After powering on the Z9100-ON switch, it goes through a power-on self-test (POST).
POST runs every time the switch is initialized and checks the hardware components to determine if the switch is fully
operational before booting. After POST, the switch uses the Grub bootloader.
To select an entry, use the up and down arrow keys. Press Enter to select an OS or enter e to edit the commands before
booting. Enter c for a command line. The selected entry runs automatically in the operating system.
Example of the Grub bootloader
GNU GRUB
version 2.02~beta2+e4a1fe391
+-------------------------------------------+
|*ONIE: Install OS
| ONIE: Rescue
| ONIE: Uninstall OS
| ONIE: Update ONIE
| ONIE: Embed ONIE
| ONIE: Diag ONIE
|
+-------------------------------------------+
Your switch comes with ONIE installed.
Example of ONIE
ONIE: Install OS
For downloading and installing an OS from a URL
Starts ONIE with ONIE Discovery Service
(factory default boot)
ONIE: Rescue
Starts ONIE without ONIE Discovery Service
Useful for running Diagnostics manually
ONIE: Uninstall OS
Restore to factory defaults erases any installed OS
ONIE: Update ONIE
For downloading and updating ONIE from a URL
ONIE: Embed ONIE
For downloading and updating ONIE from a URL and erases any installed OS
ONIE: Diag ONIE
Run Diagnostic package for Z9100-ON
During the initial setup, the switch boots to ONIE Install. ONIE Install boots with ONIE Discovery to the console (ONIE:).
NOTE:
For more information, see the Open Networking Hardware Diagnostic Guide for the Z9100–ON System.
NOTE:
After you have securely installed and powered on the Z9100-ON, to configure your switch, see your third-party
ONIE-compatible OS or the Dell EMC OS documentation.
/mnt/usb
vfat
defaults,rw,errors=remount-ro 0
defaults
|
|
|
|
|
|
|
1
0
1
Management ports
37