Award PPS902SI Instrukcja obsługi - Strona 3

Przeglądaj online lub pobierz pdf Instrukcja obsługi dla Okap wentylacyjny Award PPS902SI. Award PPS902SI 12 stron.

RECOMMENDATIONS AND SUGGESTIONS

The Instructions for Use apply to several versions of this appliance.

Accordingly, you may find descriptions of individual features that do not

apply to your specific appliance.

INSTALLATION

•

The manufacturer will not be held liable for any damages resulting from

incorrect or improper installation.

•

The minimum safety distance between the hood and heat source is 650mm.

•

Check that the mains voltage corresponds to that indicated on the rating

plate fixed to the inside of the hood.

•

For Class I appliances, check that the domestic power supply guarantees

adequate earthing.

Connect the extractor to the exhaust flue through a pipe of minimum

diameter 120 mm. The route of the flue must be as short as possible.

•

Do not connect the extractor hood to exhaust ducts

carrying combustion fumes (boilers, fireplaces, etc.).

• If the extractor is used in conjunction with non-electrical

appliances (e.g. gas burning appliances), a sufficient

degree of aeration must be guaranteed in the room in

order to prevent the backflow of exhaust gas. The

kitchen must have an opening communicating directly

with the open air in order to guarantee the entry of clean air. When the

hood is used in conjunction with appliances supplied with energy other than

electric, the negative pressure in the room must not exceed 0,04 mbar to

prevent fumes being drawn back into the room by the hood.

• The air must not be discharged into a flue that is used for

exhausting fumes from appliances burning gas or other

fuels (not applicable to appliances that only discharge the

air back into the room).

• In the event of damage to the power cable, it must be

replaced by the manufacturer or by an Award authorised service centre, in

order to prevent any risks.

2°