ALLNIC AUDIO L-7000 Instrukcja obsługi - Strona 9
Przeglądaj online lub pobierz pdf Instrukcja obsługi dla Wzmacniacz ALLNIC AUDIO L-7000. ALLNIC AUDIO L-7000 15 stron. Line-stage preamplifier
Również dla ALLNIC AUDIO L-7000: Instrukcja obsługi (10 strony)
Drukuj stronę
E.
PHASE SWITCH
On the right hand side of the top deck of the chassis, there is a phase switch. This switch is a 180
degree phase switch; phase is either normal or inverted one hundred percent, depending on the
switch position. On initial connection, set the switch to normal. Depending on the phase your
sources output and their facilities with regard to phase, you may want to switch to inverted
phase sometimes. Phase issues generally will result in lack of bass and/or focus of the stereo
image (Please see Figure 5).
F.
REMOTE CONTROL
The remote control provides the ability to remotely:
•
Select the line source input using either the numbered selector buttons (1 to 5) or the
channel up/down arrow buttons (Please see Figure 3).
•
Control the volume level using the right (louder) and left (quieter) arrow buttons adjacent
to the channel arrow buttons.
•
Mute the volume using the button labeled "MUTE". To raise the volume again after
muting, press the Mute button to take the volume level to where it was prior to muting. In
Mute mode, the light above the "operate" button on the front panel of the L-7000 will not
be illuminated; it will illuminate when the L-7000 is unmuted again.
•
Use the red power on/off button in the top left-hand corner of the remote control to
power the L-7000 on and off.
INITIAL POWER-ON
Once you have your L-7000 in place and all connections have been made to your sources and
amplifier(s) and the power cord is installed and plugged into an AC receptacle, you are ready to
turn on the power for your L-7000. Before you power up the L-7000, though, be sure you have:
•
CAREFULLY AND SLOWLY removed ALL the cardboard cushion materials from inside the
tube chimneys
•
ensured the batteries are in the remote control – if not, insert the batteries (by removing
plate on the bottom of the remote control).
•
selected the output connections that you want to use, single-ended (RCA) or balanced (XLR),
on the switch at top centre on the back of the preamplifier
•
turned the volume down on or muted the L-7000
•
checked that all your connections are snug
Also, be sure you have manually turned the volume control on the front panel to the extreme
counter-clockwise position (minimum volume).
Push the power on-off switch to the left of the IEC connector (facing the left side of the unit as
in Figure 1) so it is in the "on position". That will power up the L-7000. From this point on, you
need only use the far left hand button marked "power" on the front panel or the power button
on the remote control to turn the L-7000 on and off. Once the power has been turned on, the
following will happen on the front panel (Please see Figure 4):
•
the light above the "power" button will illuminate
•
the meters on the front panel will illuminate
9