ABB ACH580-01 Series Instrukcja szybkiej instalacji i uruchomienia - Strona 8

Przeglądaj online lub pobierz pdf Instrukcja szybkiej instalacji i uruchomienia dla Urządzenia przemysłowe ABB ACH580-01 Series. ABB ACH580-01 Series 17 stron. Base drive replacement
Również dla ABB ACH580-01 Series: Podręcznik (16 strony), Instrukcja obsługi (8 strony), Instrukcja obsługi (7 strony), Instrukcja szybkiej instalacji i uruchomienia (17 strony), Instrukcja szybkiej instalacji i uruchomienia (17 strony)

Secure the conduits outside the unit mechanically.

12. Connect the control cables

Make the connections according to the application. Keep the signal wire pairs twisted as near to the terminals as possible

to prevent inductive coupling.

Remove the rubber grommets from the cable entry for the cables to be connected. Attach cable conduits to the empty

cable entry holes. Slide the cables through the cable conduits.

Ground the shield at one end of the cable only. If you ground the shield at the source of the signal, do not ground it at

the SCR terminal.

Tie all control cables to the provided cable tie mounts.



Default I/O connections (HVAC default configuration)t

Total load capacity of the auxiliary voltage output +24V (X2:10) is 6.0 W (250 mA / 24 V DC).

Terminals

+24V, DGND, DCOM, B+, A-, DGND, Ext. 24V

DI, AI, AO, AGND, RO, OUT, IN, SGND

Safe torque off (STO). Both circuits must be closed for

the drive to start. The drawing shows the simplified

connection of a safety circuit through safety contacts. If

STO is not used, leave the factory-installed jumpers in

place. See also section Safe torque off (STO).

R6... R9 only: Ext 24V AC/DC input to power up the

control unit when the main supply is disconnected.

Wire size

0.2 ... 2.5 mm

(24 ... 14 AWG)

0.14 ... 1.5 mm

(26 ... 16 AWG)

Tightening torque

0.5 ... 0.6 N·m (5 lbf·in)