Miller 300459001 Instrukcja obsługi - Strona 6

Przeglądaj online lub pobierz pdf Instrukcja obsługi dla System spawania Miller 300459001. Miller 300459001 17 stron.

11. GMAW Connections

To prevent overheating, make sure cooling

unit is positioned so there is 12 in. (305

mm) of unrestricted airflow on sides of unit.

NOTICE − If welding power source has a

water valve, do not connect hoses to water

valve. Connect hoses as shown.

Coolant Out Hose

Coolant In Hose

Fittings have 5/8-18 left-hand threads.

Connect hoses with proper fittings as

shown.

Coolant Tank Cap

OM-235 464 Page 6

115 Or 230 Volt AC Grounded Re-

ceptacle (Depending On Model)

NOTICE − Do not cut plug from 115 volt

cord and attempt to rewire for 230 volts, or

do not cut plug from 230 volt cord and at-

tempt to rewire for 115 volts.

An individual branch circuit capable of car-

rying 15 amperes and protected by fuses

or circuit breakers is recommended. Rec-

ommended fuse or circuit breaker size is

15 amperes. For 230 volt models, an indi-

vidual branch circuit capable of carrying 10

amperes and protected by fuses or circuit

Tools Needed:

11/16 in.

breakers

recommended.

mended fuse or circuit breaker size is 10

amperes.

Operation:

You may experience pump/priming

noise during initial start-up, or after

changing or replacing coolant.

Fill tank with proper coolant. Use table in

Section 9 to select proper coolant. Maintain

coolant level at approximately 1 in (25 mm)

below top of filler neck. Connect hoses as

shown. Unit turns on when plugged in and

power switch is turned on.

805 190-B

Recom-