Miller S-74 Boom w/Drive Instrukcja obsługi - Strona 19
Przeglądaj online lub pobierz pdf Instrukcja obsługi dla Akcesoria spawalnicze Miller S-74 Boom w/Drive. Miller S-74 Boom w/Drive 32 stron. Boom w/drive
Również dla Miller S-74 Boom w/Drive: Instrukcja obsługi (32 strony)
Drukuj stronę
4-9. Removing Safety Collar And Adjusting Boom
3
1
Tools Needed:
1-1/8 in.
4-10. Wire Type, Size, And Feed Speed Capability Table
Motor Speed
Wire Type
Standard
All
Standard
All
Standard
All
Optional High
All
Speed
4
2
Rod
Increasing Spring
Pressure For A
Heavy Gun
Wire Size
.023 To 5/64 in. (0.6 To 2 mm)
3/32 To 7/64 in. (2.4 To 2.8 mm)
1/8 in. (3.2 mm)
.023 To 5/64 in. (0.6 To 2 mm)
1
Locking Knob
Tighten knob to prevent boom
movement. Loosen knob to allow
boom movement. Change knob po-
sition to limit upward movement.
Pull boom down slightly and remove
safety collar. Boom should balance
in any position from horizontal to 60
degrees above horizontal. If neces-
sary, adjust boom as follows:
2
Threaded Rod
3
Jam Nut
Loosen jam nut and turn threaded
rod until boom balances. Tighten
jam nut. Be sure several full threads
are through yoke to prevent boom
falling.
4
Yoke
Retain safety collar for use in disas-
sembling or moving boom.
Rod
4
3
2
Decreasing Spring
Pressure For A
Light Gun
Feed Speed Capability
50 To 780 ipm (1.3 To 19.8 mpm)
50 To 700 ipm (1.3 To 17.8 mpm)
50 To 300 ipm (1.3 To 7.6 mpm)
92 To 1435 ipm (2.3 To 36.4 mpm)
Ref. 152 323-B
OM-252 045 Page 15