Miller ICE-27C Instrukcja obsługi - Strona 10

Przeglądaj online lub pobierz pdf Instrukcja obsługi dla Latarka Miller ICE-27C. Miller ICE-27C 38 stron. Air-cooled torches for plasma arc cutting

11. Sequence Of Operation For 12 Ampere Torch

EXAMPLE Of Cutting Operation

For shielded cutting, place drag shield on edge

of metal. For non-shielded cutting (non-CE

only), use 1/8 in (3.2 mm) standoff distance

(dragging tip will reduce tip life).

Adjust torch speed so

sparks go thru metal and

out bottom of cut.

OM-1593 Page 10

Moisture from the compressor will form in the air line and at

the torch. It will be normal to sometimes see moisture come

out the end of the torch.

The pilot arc starts immediately when trigger is pressed.

Raise trigger lock and press

trigger. Pilot arc starts.

Pause briefly at end of

cut before releasing trigger.

After cutting arc starts, slowly

start moving torch across metal.

Postflow continues for approx. 12 seconds

after releasing trigger; cutting arc can be in-

stantly restarted during postflow by raising

trigger lock and pressing trigger.

801 400-A