Aquatel D110-S Instrukcja obsługi - Strona 9

Przeglądaj online lub pobierz pdf Instrukcja obsługi dla Monitor Aquatel D110-S. Aquatel D110-S 12 stron. Wireless level monitor

tank unit setup -

T o remove a Tank Unit, select Remove tank and select which tank unit you wish

to remove. Please note that at least one Tank Unit must always be paired with

the Display, you will need to add a new Tank Unit before you can remove the last

one. You can configure any Tank Unit paired with the Display Unit by selecting

"Configure tank unit", here you will be able to change the name, move to another

position, change the alarm levels, top air gap etc.

system

System Settings

measurement interval

Y ou can adjust the update interval from 1-30

minutes on each Tank Unit paired, this is

helpful if you need more frequent updates on

smaller tanks/cisterns or less frequent updates

on a larger tank/cistern you are monitoring.

The longer the update interval the longer the

batteries will last in the Tank Unit.

note:

- When the tank unit is in test mode the level

information updates every 20 seconds

- When out of test mode the tank unit will update at the next scheduled reading interval.

to force an update immediately, remove the tank unit lid and press the reset button.

reading beeps:

reading beeps can be turned off under the System Settings menu.

lock unit (For aquatel authorised installers only):

to prevent tampering and changes to alarm level settings. (Changes can still be made to the

clock and measurement interval)

note: only aquatel authorised installers are able to obtain unlock codes from the login section of

the aquatel website.

Factory reset:

note: the unit can not be reset if the unit is locked.

continued

When set to ON the Display Unit beeps when a new reading is received,

Reset all settings to factory defaults.

System installers can lock the unit

– 8 –