aquatherm AT600 Instrukcja obsługi dla właściciela - Strona 12

Przeglądaj online lub pobierz pdf Instrukcja obsługi dla właściciela dla Pompa ciepła aquatherm AT600. aquatherm AT600 12 stron. Swimming pool & spa heat pumps
Również dla aquatherm AT600: Instrukcja obsługi dla właściciela (12 strony), Instrukcja instalacji (16 strony)

Drukuj stronę

Warranty Service

Before calling for warranty service you should check the following:

1. Clean all ﬁlters and traps in the pool circulation system. Low water ﬂow will cause the

unit to shut down or cycle.

2. Check and adjust all water ﬂow valves and adjust to the proper positions to insure

proper water ﬂow through the heater.

3. Check the water pump timer setting to insure there is enough time allotted for a proper

heating cycle.

4. Check all circuit breakers and disconnects. Note: More than one disconnect may be

required to shut off or turn on power to the heater.

5. Conﬁrm that all heater controls, thermostat, thermostat selector switch, reset tripper,

and optional auto heat switch (if so equipped), are in the correct position.

6. If any 3rd party control devices are installed on the pool/spa system make sure they are

functioning properly. Factory service technicians will not diagnose 3rd party external

control devices. All external controls are disconnected during warranty service and

the heater is diagnosed as manufactured then reconnected.

7. The limited factory warranty does not cover damage or conditions caused by but not

limited to the following:

Improper installation.

Improper use.

Inadequate run time on the water pump timer.

Improper water ﬂow to the heater.

Conditions caused or associated with 3rd party external controls.

Chemical damage or improper water balance.

Sprinkler damage.

Roof run off damage.

Freeze damage or operation damage during freezing conditions.

Salt and/or sand/debris damage.

Lack of maintenance and/or cleaning.

Unauthorized servicing of the heater during the warranty period.

Normal rusting and oxidation of metal components.

Non warranty service calls such as inspections, maintenance, or problems unre-

lated to the heater as it was manufactured are not covered under the warranty.

8. You can contact the factory @ 888-297-3826 to be pre-qualiﬁed and scheduled with

a factory authorized service center in your area. Have your model number, serial

number and installation date ready.

Important Notes:

The heater will not heat faster if you turn the thermostat all the way up. The heater will

never run without water running through it from the pool/spa ﬁlter pump. When the heater

is started the fan will run right away. The compressor will start after a 5 to 7 minute delay.

The heating light will come on only when the compressor is running.

The heater will produce condensation at a steady rate. The condensation exits the heater

from the bottom drains. The more humidity the more condensation. The thermostat is

accurate within three degrees and may not always match exactly to the degree numbers

printed on the control panel as it is effected by the humidity and other factors. The heater is

designed to shut off in defrost mode when the air temperature drop below 45˚F to 50˚F.

Speciﬁcations may change without notice.