Aquatic AQ-BC-6UBT Instrukcja obsługi i instalacji - Strona 6
Przeglądaj online lub pobierz pdf Instrukcja obsługi i instalacji dla Odtwarzacz multimedialny Aquatic AQ-BC-6UBT. Aquatic AQ-BC-6UBT 16 stron. 'hide-away' media player for bluetooth, usb, iphone, ipod, mp3 devices, and fm radio
Również dla Aquatic AQ-BC-6UBT: Instrukcja obsługi i instalacji (13 strony)
Drukuj stronęGetting Started
1.7 Power On
The AQ-BC-6UBT requires +12V DC to both the red and yellow wires. When both of these wires
have power the AQ-BC-6UBT is always powered on, indicated by a red LED on the heatsink of the
stereo. Ground is connected to the black wire.
In a spa application this requires the red and yellow wires to be jumped together and then con-
nected to the +12VDC output of the power source. In this set up the AQ-BC-6UBT will always be
on, with a very low current draw when idle.
In a boat, ATV or other application requiring power from a battery, the yellow wire (constant
power) should be connected to the battery, and the red wire should be connected to the ignition
or a switch.
For detailed instructions you can check out our online video:
1.8 Handheld Remote Control Charging
The remote has a built-in Polymer Lithium rechargeable battery and comes with a charging
cable. Connect one end of the charging cable to the charging connection on remote control
and connect the USB end of the charging cable to any USB charger (5V DC) for charging.
Make sure the remote has been charged before used.
1.9 Handheld Remote Control Synchronizing
The remote should already be paired from the factory, but if you need to synchronize the
remote, follow the steps below.
1. Make sure BlueCube+ Media Player is powered ON (red LED)
2. Put the remote within 0.5 meter of the BlueCube+ Media Player.
3. Press and hold MODE on remote control until the LCD shows "Pairing in Progress". Re-
lease the button.
4. WIthin 2 seconds, the LCD will show "Paired". If it fails to pair, the LCD will show "Retry
again". If this happens, wait 5 seconds and repeat steps above.
For any additional remote controls, you will also need to synchronize those remote controls to
the BlueCube+ Media Player.
If the pairing process is not successful, try again to put your remote close to the remote receiver or charge the remote
control if the battery is low.
Depending on the frequency of usage, the remote may drain its battery. Please charge the remote before use. If the LCD
shows nothing, the battery has been drained and will need charging.
If you have lost or damaged your remote control and buy a new remote control, follow the above steps to pair the
new remote control.
www.aquaticav.com
'How to wire your Aquatic AV stereo system'
http://www.aquaticav.com/support/videos
BlueCube+ Media Player AQ-BC-6UBT
6