Aquatic BLUECUBE+ AQ-BC-6UBT-X Instrukcja obsługi i instalacji - Strona 6

Przeglądaj online lub pobierz pdf Instrukcja obsługi i instalacji dla Odtwarzacz multimedialny Aquatic BLUECUBE+ AQ-BC-6UBT-X. Aquatic BLUECUBE+ AQ-BC-6UBT-X 18 stron. 'hide-away' media player

Drukuj stronę

Getting Started

1.4. Mounting the BlueCube+ Media Player

1. Make sure the outside surface is clean and

clear of debris.

2. The BlueCube+ Media Player has four (4)

front screws. Drive the screws using a screw

driver. Make sure screws are snug and do not

over tighten.

1.5 Bluetooth Antenna Installation

1. Screw on the provided Bluetooth Antenna,

avoiding bending the cable at a 90° angle.

2. Install the Bluetooth antenna as high as

possible, above the waterline of the spa if

possible, and making sure the arrow is pointing

directly upwards towards the sky to ensure the

Bluetooth range is maximized. If there is no

suitable surface to screw it in, we recommend

using a good quality double sided tape.

1.6 Power Attenuation Wires

The AQ-BC-6UBT-X Bluecube+ Media

Player's power can be reduced or increased

to suit different applications. An output

level of -3dB or -6dB should be used to

avoid blowing very small speakers, often

used in spa applications.

By cutting only the white wire the output level will decrease to -6dB below the nominal 0dB.

By cutting both the white and black wires the power/volume will increase to +6dB above the

nominal 0dB.

By cutting only the black wire the power/volume will increase from -3dB to the nominal 0dB.

These modifications should only be carried out by an experienced audio installer.

Should you cut the wrong wires or wish to reconnect them to further alter the attenuation, the Power Attenuation

Wires can be crimped back together.

www.aquaticav.com

BlueCube+ Media Player AQ-BC-6UBT-X

Black Wire

White Wire

Intact (not cut)

Cut

Intact (not cut)

Cut

Output Level

-3dB

-6dB

0dB (reference)

+6dB