Aquatic SWA6+ Instrukcja obsługi i instalacji - Strona 8
Przeglądaj online lub pobierz pdf Instrukcja obsługi i instalacji dla Subwoofer Aquatic SWA6+. Aquatic SWA6+ 18 stron. Combined bluetooth stereo subwoofer with full range speaker outputs
Drukuj stronęGetting Started
1.8 Handheld Remote Control Charging
The remote has a built-in Polymer Lithium rechargeable battery and comes with a charging cable.
Connect one end of the charging cable to the charging connection on the remote control and con-
nect the USB end of the charging cable to any USB charger (5V DC) for charging.
Make sure the remote has been charged before used.
1.9 Handheld Remote Control Synchronizing
The remote should already be paired from the factory, but if you need to synchronize the remote,
follow the steps below.
1. Make sure SWA6+ is powered ON (green LED)
2. Put the remote within 0.5 meter of the SWA6+.
3. Press and hold MODE on remote control until the LCD shows "Pairing in Progress".
Release the button.
4. Within 2 seconds, the LCD will show "Paired". If it fails to pair, the LCD will show
"Pairing Failed". If this happens, wait 5 seconds and repeat steps above.
For any additional remote controls, you will also need to synchronize those remote controls to the
SWA6+.
If the pairing process is not successful, try again to put your remote close to the remote receiver or charge the remote
control if the battery is low.
Depending on the frequency of usage, the remote may drain its battery. Please charge the remote before use. If the LCD
shows nothing, the battery has been drained and will need charging.
If you have lost or damaged your remote control and buy a new remote control, follow the above steps to pair the
new remote control.
www.aquaticav.com
Combined Stereo Subwoofer SWA6+
8