HTC 420 VS Podręcznik użytkownika - Strona 28
Przeglądaj online lub pobierz pdf Podręcznik użytkownika dla Maszyna podłogowa HTC 420 VS. HTC 420 VS 46 stron. Floor grinder | concrete floor sander
Również dla HTC 420 VS: Podręcznik (50 strony)
Drukuj stronęOperation
Warning!
Only cold water with no chemical additives may be used.
5.
4.7. Control
The machines functions can be controlled using the control panel -
see Figure 3-3 on page 11.
During operation, the operator pushes the grinder forward over the
floor surface.
4.7.1. Standby
In order to activate the machines functions, turn thePowerknob
to"I".Once the knob set to this position, the Power indicator on the
control panel lights up, indicating that the machine is in stand by
mode.
4.7.2. Emergency stop switch
The emergency stop switch, (EM-Stop) must only be used in an
emergency.
When the switch is pressed, all electrically-operated equipment in
the machine is turned off.
Note!
Do not use the emergency stop switch to stop the machine other
than in emergencies, as it causes wear to the contactor.
Note!
As long as the emergency stop switch (EM-Stop) is pressed, the
machine cannot be started. Reset by turning the switch 45° so that
it pops out again. The machine can then be restarted.
4.7.3. Starting the machine
For a description of the control panel, see Figure 3-3 on page 11.
1.
20
Fill the tank with cold water.
Insert the cord.
HTC 420 VS
3.0