Olympus MX61 Instrukcja montażu - Strona 26

Przeglądaj online lub pobierz pdf Instrukcja montażu dla Mikroskop Olympus MX61. Olympus MX61 49 stron. 200mm/300mm compatible semiconductor/fpd inspection microscopes

Drukuj stronę

2-3 Modules Installed by Olympus

The modules described in the following sections are installed and adjusted by Olympus. The user

should not install and/or adjust them.

# When installing the modules, the personnel of Olympus must take caution not to put fingerprints or

scratches on them.

Transmitted Light Module (MX-TILLA/TILLB)

1. Remove the stage.

2. Insert one of the provided clamping screws (AB 3 x 25) into each of the four screw holes on the condenser @ by means

of a washer, and drop the condenser in to the opening ² on the focusing block so that it faces the front direction (i.e. so

that the AS lever or shutter comes on the front).

3. Place the condenser by pushing it against the left and deep directions when the microscope is seen from the front, and

tighten the four clamping screws (AB3 x 25) using an Allen wrench (2.5 mm). The attaching of the type A model is now

complete.

4. With the type B model, clamp the interlock section ³ of the condenser height adjustment ring into the four threaded

holes on the front part of the focus adjustment section using the provided clamping screws (AB3 x 5) and Allen wrench

(2.5 mm). After clamping temporarily, find the positioning with which the gear interlocking is smooth and tighten the

clamping screws firmly.

5. Using a Phillips screwdriver, loosen the clamping screws (CTK3 x 6) on the cover plate on the right of the base, and

remove the cover plate.

6. Raise the focus adjustment section to the highest position, align the dovetail groove ƒ of the illuminator unit | with the

internal dovetail, fit them all the way, and tighten the clamping screws of the internal dovetail using the Allen screwdriver.

To prevent loosening the condenser, screw in the provided screws (AHU 5 x 6) additionally above the clamping screws

(using the Allen wrench with a width across flats of 2.5 mm).

7. Attach and clamp the illuminator unit cover ... using the clamping screws (CTK 3 x 6) so that the spaces of the openings

are uniform with respect to the outward projections of the illuminator unit |.

8. Loosen the light guide holder clamping screw † and pull out the light guide holder by holding the knob ‡.

9. Insert the light guide Š into the light guide holder and tighten the clamping screws on the side.

10. Attach the light guide holder in the original position and eighteen the clamping screw †.

...

†

‡