Olympus PT E06 Instrukcja obsługi - Strona 19

Przeglądaj online lub pobierz pdf Instrukcja obsługi dla Akcesoria do kamer Olympus PT E06. Olympus PT E06 30 stron. Underwater camera case

Seal the Case

1 Close the rear lid gently (so that the O-rings do not slip

out of the grooves).

2 Turn the open/close dial clockwise.

• The Case is sealed when the position of the slide lock

is at the top.

CAUTION:

If the open/close dial is not fully turned, the Case will not be sealed airtight and water leakage may occur.

After sealing the Case, check that the camera functions normally.

• Operate the power switch lever on the Case and confirm that the camera can be turned ON/OFF.

• Turn the mode dial knob on the Case and confirm that the camera mode switches properly.

• Operate the shutter lever on the Case and confirm that the camera shutter is released.

• Operate the zoom dial on the Case and confirm that the camera's lens is controlled.

• Operate other control buttons on the Case and confirm that the camera functions properly as intended.

After closing the case tightly, check the seal between the front and rear lids and the connection between

the port and case to make sure the O-rings are not twisted, that they sit properly in the grooves, and that

no foreign matter has been caught between the two parts.

CAUTION:

Hair, fiber, and other narrow items are not very apparent, but they may cause entry of water, therefore special

attention is required.

EN 18