Axvue E610 Instrukcja obsługi - Strona 6

Przeglądaj online lub pobierz pdf Instrukcja obsługi dla Elektroniczna niania Axvue E610. Axvue E610 11 stron.

Drukuj stronę

Please refer to the manual carefully instructions to set up and use

Installation and use 1

Testing Inital Setup: Before useing AXVUE Baby

Monitor, charging the 6-8 hours . Note:

STRANGULATION HAZARD - Children have STRANGLED in

cord out of reach of children, (more than 1m away

from the crib) Use enclosed Security Clips to help

secure cord away from baby's reach. Never use

extension cords with Adapters. Only use the Adapters

provided.

Step1: To test reception, determine a location for the

camera that will provide the best view fo your baby in the

crib (note: do not mount camera in permanent location

until initial set up test completed). Plug Adapter into wall

outlet and turn camera power on.

Step2: Press and hold POWER/MENU button on monitor

for 5-seconds unit AXVUE the logo interface and power

on screen. Video should immediately appear on screen.

If video does not appear, go refer to "set up and use "checking

the installation is complete, (Note: use only the

supplied power adapter, Model: P50750500)

Note: If video appears, the initial set up test is

complete.

Installation Camera: Place the camera on a flat

surface,such as a bureau or shelf (Picture 1) or mount the

camera on a wall(Picture 2) for example: on the desk or

cabinet or fixed to the wall, make sure that at least 1

meter from the crib, power lines should be placed

above or behind the camera, adjust the camera

angle, until the display see the entire crib, or do you

think the best line of sight.

Wall Mounting：(choose to buy)

1 Pre-drill a hole in the wall, a 4.8mm drill bit..

2 Insert the wall anchor included into the holo and with a hammer

tap gently on the end until the wall anchor is flush with the wall

3 Tighten screw until only 6.2mm of the screw is exposed.

4 Insert camera Adapter into the camera's adapter jack.

5 Sile the back of the camera down onto the screw until the camera

is secure to the wall.

6 Plug the Adapter into a standard electrical outlet.

7 Secure the cord to the wall using the security clips included to keep

cord away from baby's reach.

Set up & Use

Tips

Since most users choose desktop display camera

for the sake of environmental protection, product

packaging is not included in the wall and screw clips

and, if necessary, to buy at the official website of the

company or .

Picture1

Fixing cable with clip

Picture2