Epson AcuLaser C8500 Skrócona instrukcja obsługi - Strona 16

Przeglądaj online lub pobierz pdf Skrócona instrukcja obsługi dla Drukarka Epson AcuLaser C8500. Epson AcuLaser C8500 21 stron. Epson aculaser c8500: quick start
Również dla Epson AcuLaser C8500: Instrukcja rozpakowywania (20 strony)

Epson AcuLaser C8500 Skrócona instrukcja obsługi
Messages
Description
There is not enough memory for
duplex printing. The printer prints
only on the top side and ejects the
paper. To correct this error, follow
the instructions below.
If
SelecType Config Menu, either
press Continue or reset the printer
by pressing the ALT and Reset
buttons at the same time.
If
SelecType Config Menu, the error is
automatically corrected after a
certain period of time.
An unformatted ROM module has
/
been inserted. If the ROM module
has been formatted, but is
unreadable, format it again. If the
ROM is still unreadable after
reformatting, take it to your dealer
for repair or replacement.To clear
this error, either press the Continue
button or turn off the printer and
remove the ROM module.
The front cover is open. Close the
cover and the error is automatically
cleared.
is set to
in the
is set to
in the
Messages
Description
There is insufficient memory to print
the page at the specified print
quality. The printer automatically
lowers the print quality so that it can
continue printing. If the quality of
the printout is not acceptable, try
simplifying the page by limiting the
number of graphics or reducing the
number and size of fonts.
Press the Continue button or reset
the printer to clear the message.
Turn the
the SelecType Config Menu if you
do not want the printer to
automatically lower the print
quality to continue printing.
You may need to increase the
amount of printer memory to be
able to print at the desired print
quality for your document.
The photoconductor unit is not
installed, or is installed incorrectly.
Install a photoconductor unit if it is
not installed.
If the photoconductor unit is
already installed, try removing it
and then reinstalling it into the
printer.
setting off in
16
16
16
16