ABB RHD 8000-80 Instrukcja obsługi - Strona 15

Przeglądaj online lub pobierz pdf Instrukcja obsługi dla Kontroler ABB RHD 8000-80. ABB RHD 8000-80 17 stron. Electrical part turn actuators for continuous modulating control (contrac)

Drukuj stronę

11.3.2

Mounting

The toothed gear pair of the position sensor is held in place by a tension spring (3),

to ensure backlash-free motion when the direction of rotation is reversed.

- set the stop pin to the center position, as shown in Figure 14.

- align the sensor and its gears with the actuator; set the first toothed gear in

09:00 o'clock position (fig. 15) onto the drive shaft gear (4).

- slightly move the sensor back and forth to pre-tension the toothed gears with the

difference "z" until the second toothed gear snaps in.

- fasten the screws (1) tightly.

- fasten sensor cable plug on sensor pcb

(r00329x1)

Fig. 14: Position sensor

After mounting is completed readjust the actuator range as described in the setup

section of this manual.

sensor cable

Fig. 15: Mounting position (Example shows RHD 500)

position sensor