ABB TZIDC Instrukcja obsługi - Strona 5

Przeglądaj online lub pobierz pdf Instrukcja obsługi dla Kontroler ABB TZIDC. ABB TZIDC 10 stron. Digital positioner
Również dla ABB TZIDC: Szybki start (2 strony), Szybki start (3 strony), Instrukcja serwisowa (4 strony), Instrukcje uruchomienia (2 strony), Podręcznik (8 strony)

Drukuj stronę

Commissioning

1. Turn on the air supply to the positioner.

2. Apply the 4...20 mA analog input signal to the positioner.

3. Check for proper mounting:

Press and hold

Additionally briefly press

range) is displayed.

Release

MODE

Press

note the values. The angle of rotation is indicated in degrees.

Recommended positions of limit stops:

> -28° and < +28° for linear actuators

> -57° and < +57° for rotary actuators

Minimum angle: 25°

4. Switch to the configuration level:

Press and hold

Additionally briefly press

Wait until the countdown from 3 to 0 is completed.

Release

and

The device will automatically go to parameter group P1.

5. Select the actuator type (parameter P1); select ROTARY or LINEAR using

This step must be performed prior to Autoadjust (step 6).

Caution

6. Start Autoadjust:

Press and hold

Additionally briefly press

Release

MODE

Press

ENTER

Release

ENTER

Autoadjust is started.

If the message "COMPLETE" is displayed to indicate successful Autoadjust, briefly

press

ENTER

It is also possible that Autoadjust is automatically cancelled due to troubles, and an

error message is displayed. See "P 1.1 Autoadjust" on page 53 for details.

42/18-64-4 EN

MODE

until mode 1.3 (manual adjustment within the sensor

to move the actuator to its mechanical limit stops in both directions, and

and

simultaneously.

ENTER

MODE

; until "P1.1" is indicated.

and keep it pressed until the countdown is finished.

to acknowledge.

Brief operating instructions