ARCO Arcade 3 Procedura instalacji - Strona 3

Przeglądaj online lub pobierz pdf Procedura instalacji dla Otwieracz drzwi garażowych ARCO Arcade 3. ARCO Arcade 3 7 stron. Industrial/ larger aluminium roller shutters

Drukuj stronę

STEP 1 : MEASUREMENTS/CHECKLISTS

Before installation, confirm the following:

 CHECK DAYLIGHT WIDTH & DRUM WIDTH

Drum length approximately 250mm longer than the Daylight Opening Width.

 CHECK HEAD ROOM

Head Room must be minimum of 650mm

Daylight Height must be levelled



CHECK SIDE NIB

If shutter is electric operated, Drive Side must be minimum of 400mm, Non-Drive Side must

be minimum of 240mm (as shown in Figure 1)

If shutter is manual operate, nib width for both sides is 240mm (As shown in Figure 2)

STEP 2 : INSTALLATION



Determine the angle bracket location.

Behind Wall Fixing*

The horizontal distance between face of angle bracket and door opening follows following:

If shutter is electric operated, the horizontal distances between face of angle bracket and

door opening (shown in Figure 3) are

For Drive Side: L

For Non-Drive Side L

Where: Drum Overlap = Drum Length – Daylight opening width

If shutter is manual operated, the horizontal distances between face of angle bracket and

door opening (shown in Figure 4) are the same for both side, which is:

L = Drum Overlap + 40mm

Mark out Bracket positions 200mm above lintel to bottom of the Angle Bracket vertically (as

shown in Figure 5)



Using a level ( Laser) to line up the top of the two (2) Angle Brackets, fit the Angle Bracket (it

is critical that the two (2) Angle Brackets are levelled).



Bolt end bracket to the outside of angle bracket either one side of angle bracket if manual

operated. If electric operated, bolt Motor Bracket to the outside face of the Angle Bracket at

drive side.



Remove Capstan Wheel from Drum Shaft and fit non drive bracket to drum shaft then

replace capstan onto drum shaft.



Lift Drum Assembly up and slide Drive Side Drum Shaft into Drive Side Bracket, position End

Side Bracket and bolt to outside of Angle Bracket.



If the shutter is electric operated, bolt Motor to the Motor Bracket to the outside of the

Bracket, fit drive sprocket to motor and line it up with drum sprocket and tighten grub

screws, fit drive chain to motor and drum sprockets and tension. Fit Hand Chain to motor.



Lift curtain into position under the drum (ensure the curtain is the right way around) and

suspend in slings (2 off approximately 700mm from each end).

Arco Qld Pty Ltd/Manual

Page 3 of 7

= Drum Overlap + 60mm

= Drum Overlap + 40mm