Epson XP-600 Podręcznik podstawowy - Strona 20

Przeglądaj online lub pobierz pdf Podręcznik podstawowy dla Drukarka Epson XP-600. Epson XP-600 24 stron. Xp-600 impresora small-in-one
Również dla Epson XP-600: Instrukcja uruchamiania (4 strony), Skrócona instrukcja obsługi (40 strony), Podręcznik (46 strony), Zacznij tutaj (4 strony), Specyfikacja produktu (2 strony), (Podręcznik instalacji (4 strony)

Basic Guide

Basic Troubleshooting

This section describes the meaning of messages displayed on the LCD screen.

Error Messages

Paper jam

Paper out

Photos not recognized. Place the photos correctly on the

scanner glass.

Printer error. Turn the power off and on again. For details,

see your documentation.

Communication error. Check if a computer is connected.

A printer's ink pad is nearing the end of its service life.

Please contact Epson Support.

A printer's ink pad is at the end of its service life. Please

contact Epson Support.

Memory card or external device not recognized.

Combination of IP address and subnet mask is invalid. See

your documentation.

Recovery Mode

Basic Troubleshooting

Solutions

& See "Paper Jams" on page 19

& See "Loading Paper" on page 5

& See "Scanner glass" on page 10

Turn the product off and then back on. Make sure that no paper is

still in the product. If the error message still appears, contact Epson

support.

Make sure the computer is connected correctly. If the error

messages still appears, make sure that scanning software is

installed on your computer and that the software settings are

correct.

Press x to resume printing. The message will be displayed until

the ink pad is replaced. Contact Epson support to replace ink pads

before the end of their service life. When the ink pads are

saturated, the printer stops and Epson support is required to

continue printing.

Contact Epson support to replace ink pads.

Make sure memory card or external device has been inserted

correctly.

Refer the online Network Guide.

The firmware update has failed. You will need to re-attempt the

firmware update. Ready a USB cable and visit your local Epson

website for further instructions.