ACD DS210 Series Krótki przegląd - Strona 13
Przeglądaj online lub pobierz pdf Krótki przegląd dla Urządzenia przenośne ACD DS210 Series. ACD DS210 Series 15 stron.
Również dla ACD DS210 Series: Dokumentacja sprzętowa (20 strony)
Drukuj stronę5.7 Status of the DS210 docking station LEDs
The DS210 status LEDs are located on the front of the docking station.
Fig. 7: Status of the DS210 LEDs
The POWER LED shows a green light as soon as the DS210 is supplied with current via the power supply
unit.
The CHARGE LED shows a red light when the M210 is charging. The LED shows a green light once the
M210SE is charged. In order to ensure a correct display, the M210SE must be switched off. If the M210SE is
switched on, the CHARGE LED may show a red light although the battery is already charged.
The 2. BATTERY LED shows a red light if a spare battery is being charged. The LED shows a green light
once the spare battery is charged.
With the DS210 Ethernet, the CONNECT LED flashes green if the DS210 is connected to the LAN (Ethernet)
with a network cable and the M210SE has loaded the Ethernet driver. Therefore, the CONNECT-LED has
the same function as the green Link LED on the network socket (RJ45 with two integrated LEDs) on the rear
of the device. The yellow LED is the Tx LED. It flashes if data is being transmitted from the M210SE into the
LAN via the DS210.
Tx LED
Power
Supply
Figure. 8: RJ45 connector with LEDs
6 Cleaning and maintenance information
Clean the device by placing it firmly onto a surface (e.g. table). This ensures a secure hold and the device
cannot slip out of your hand during the cleaning process.
6.1 Display
If required, clean the display with a soft, dry cloth. In order to do, always switch off the device as the display
responds to all contact and could therefore compromise or interfere with the active program. Do not apply
any severe pressure on the display.
6.2 Charging and communication contacts
If transfer problems occur, clean the charging and communication contacts with a soft, moist cloth.
When dealing with the DS210, the power plug must be disconnected beforehand.
6.3 Scanner, camera and camera light window
In the event of any irregularities during scanning, switch off the device and clean the scanner window with
a soft, dry cloth. The scanner window is ultra-transparent and can hardly be seen with the naked eye.
Attempt to carefully clean the window without applying excess force on the glass.
M210SE_Set_Kurzübersicht_V1 03_de_en.doc
Link LED
13 / 15