Cisco 3640 Series Skrócona instrukcja obsługi - Strona 29

Przeglądaj online lub pobierz pdf Skrócona instrukcja obsługi dla Router sieciowy Cisco 3640 Series. Cisco 3640 Series 37 stron. Rack-mount and wall-mount
Również dla Cisco 3640 Series: Instrukcja instalacji (10 strony), Instrukcja obsługi (17 strony), Podręcznik użytkownika (26 strony), Podręcznik (10 strony), Uwaga dotycząca konfiguracji (18 strony)

Step 10 Respond to the following prompts as appropriate for your network:

Configuring interface FastEthernet0/0:

Use the 100 Base-TX (RJ-45) connector? [yes]:

Operate in full-duplex mode? [no]: yes

Configure IP on this interface? [yes]:

IP address for this interface: 10.1.1.1

Subnet mask for this interface [255.0.0.0] : 255.255.0.0

Class A network is 10.0.0.0, 16 subnet bits; mask is /16

Step 11 After the following messages appear, press Return to save the basic configuration:

The following configuration command script was created:

hostname 3600

enable secret 5 $1$Ksjf$za4T2lb3ARS5d1PHVzW5A0

enable password xxxx

line vty 0 4

password xxxx

snmp-server community public

no ip routing

interface FastEthernet0/0

no shutdown

media-type 100BaseX

full-duplex

ip address 10.1.1.1 255.255.0.0

interface FastEthernet0/1

shutdown

no ip address

end

[0] Go to the IOS command prompt without saving this config.

[1] Return back to the setup without saving this config.

[2] Save this configuration to nvram and exit.

Enter your selection [2]: 2

% You can enter the setup, by typing setup at IOS command prompt

Press RETURN to get started! RETURN

Step 12 The user prompt appears.

3600>

When you have completed the initial configuration tasks, your Cisco router is ready to configure for specific functions. See the

"Where to Go Next" section on page 32 for information about locating documentation for advanced configuration procedures.