Acdeos AXS-MDStep Skrócona instrukcja obsługi - Strona 6
Przeglądaj online lub pobierz pdf Skrócona instrukcja obsługi dla Akcesoria samochodowe Acdeos AXS-MDStep. Acdeos AXS-MDStep 13 stron.
Always try to go as vertically as possible straight up from
the fixing point on the rear of the step to the fixing points
on the vehicles floor.
Adjust the step so that it is horizontal under the vehicle.
Finally fit all bolts and nuts to complete the mounting of the
step.
You can adjust the height of the step under the vehicle by
adjusting the front brackets in the slot holes.
4.2
Mechanical adjustment
The step is being pushed out by two helical springs. The force at the springs can be adjusted
at a installed step under the vehicle.
There are two preload adjusters at the bottom plate of the step. To adjust the load, bring the
step in "out" position. Lose the two M8 bolts a little. Remove the two locking screws. Place a
6 mm hex key in the hex hole and adjust the load to plus or minus. After adjusting fix the
locking screws and M8 bolts. Both sides need to be in the same position after adjustment.
Remove
Lose a bit
4.3
Electrical Installation
The step comes standard without cable loom, only with a simple close switch. A wiring loom
should be made according schedule in appendix 1.
Optional original cable loom including connector fuse and dashboard LED is available under
number S130 000 Ask your dealer for availability
Pls note that a safety Light at the dashboard in sight of the driver is strongly recommended
and in some countries legally required.
The connector used at the step is of the type AMP Super seal 2 pole male C 282080-1
The counter part is AMP SUPERSEAL 2 Way, 1 Row Female Connector Housing 282104-1
Remove
Lose a bit
6