CA.MI NEW ASKIR 118 BASIC Instrukcja obsługi - Strona 8

Przeglądaj online lub pobierz pdf Instrukcja obsługi dla Sprzęt medyczny CA.MI NEW ASKIR 118 BASIC. CA.MI NEW ASKIR 118 BASIC 15 stron.

Filter assembling

Ensure that the filter is fitted with the Arrows at the patient side.

WARNING: The inside of the medical device must be regularly checked for the presence of liquids or other visible contamination

(secretions). If liquids or other visible contamination are present, the medical device must be replaced immediately due to the risk

of insufficient vacuum flow. These products have been designed, tested and manufactured exclusively for "single use" and for a

period of use not exceeding 24 hours unless stated below.

WARNING: The seal hook placed on the ASKIR 118 SUPPORT (mod. ASU 118) is the dividing element from the 12V mains, even if

the device is equipped with the specific ON/OFF button.

A pressure sensor fitted in the device allows decreasing the motor revolutions [in the absence of suction] safeguarding the internal

battery life. The motor will resume full speed only when the operator carries out the body fluid aspiration process (with the

adjustment knob set to +). If the operator does not carry out the suction process the device lowers the number of revs of the motor,

thus protecting the duration of the internal battery.

WARNING: Before using the device, check the battery power status. Before each use proceed with charging the

battery. To maintain the device in good conditions, recharge the battery every 3 months (when not in use).

Recharging operations: to be able to charge the internal battery it is necessary to connect the universal switching adapter

(mod. UE60-140429SPA1 of FUHUA) to the electric network for approx. 360 minutes with the main switch to position 0.

The battery's autonomy when fully charged is approx. 70 minutes with continued operations.

Operation using with AC/DC switching adapter : The symbol

indicates that the instructions must be viewed before each user operation, identifying the model and type of power supply to be

connected, in line with the information mentioned in the instructions for use.

NEVER USE THE DEVICE WITHOUT JAR AND / OR PROTECTION FILTER

positioned near the 12V jack on the device casing