ACU-RITE 00639W Instrukcja obsługi - Strona 15

Przeglądaj online lub pobierz pdf Instrukcja obsługi dla Stacja pogodowa ACU-RITE 00639W. ACU-RITE 00639W 20 stron.
Również dla ACU-RITE 00639W: Instrukcja obsługi (14 strony)

Drukuj stronę

Troubleshooting

Problem

No outdoor sensor

reception

no bars

Outdoor

temperature

is flashing or

showing dashes

Inaccurate wind

readings

Display screen

not working

• Relocate the display unit and/or the 3-in-1 sensor.

The units must be within 330 ft (100 m) of each other.

• Make sure both units are placed at least 3 feet

(.9 m) away from electronics that may interfere with

the wireless communication (such as TVs, microwaves,

computers, etc).

• Use standard alkaline batteries (or lithium batteries in

sensor when temperature is below -4ºF/-20ºC). Do not

use heavy duty or rechargeable batteries. NOTE: It

may take up to 20 minutes for display unit and sensor

to synchronize after batteries are replaced.

• Synchronize the units:

1. Bring both the sensor and display unit indoors and

remove batteries from each.

2. Make sure the A-B-C switch on both units match.

3. Reinstall batteries in the outdoor sensor.

4. Reinstall batteries in the display unit.

5. Let the units sit within a couple feet of each other

for about 20 minutes to gain a strong connection.

Flashing of the outdoor temperature may be an

indication of wireless interference.

• Make sure the A-B-C switch in the battery

compartments of both the display unit and sensor are

switched to the same letter. You may choose A, B or

C; but both units must match to sync up.

• What is wind reading being compared to? Pro

weather stations are typically mounted at 30 ft high

or more. Make sure to compare data using a sensor

positioned at the same mounting height.

• Check location of the sensor. Ensure it's mounted a

minimum of 5 ft in the air with no obstructions around

it (within several feet).

• Ensure wind cups are spinning freely. If they hesitate

or stop try lubricating with graphite powder or spray

lubricant.

• Check that the batteries are installed correctly.

Batteries may need to be replaced.

• Reset the display by pressing the "RESET" button,

located in the battery compartment of the display

unit.

Possible Solution