Epson Stylus Pro 4000
Message/
Light
Light
PAPER NOT
Paper
CUT
light
flashing
PAPER NOT
Paper
STRAIGHT
light
flashing
PAPER OUT
Paper
light on
REAR COVER
—
OPEN
RELOAD
Paper
PAPER
light on
RELOAD
Paper
PAPER
light on
INSERT
DEEPLY
REMOVE
Paper
PAPER
light on
6 - Epson Stylus Pro 4000
Explanation
Response
Roll paper was
Open the top cover
not cut correctly.
and remove the
uncut paper. Reload
paper if necessary.
The cutter may
Reinstall or replace
be blunt or
the cutter blade if
incorrectly
necessary (page 10).
installed.
Paper slipped
Reload paper,
and fed into the
making sure the
printer at an
edges are straight.
angle.
No paper is
Load paper.
loaded.
Paper ran out.
Remove any
printouts or paper
remaining in the
printer and load
more paper.
If the message
appears during a
print job, reset the
printer by pressing
the Pause button for
3 seconds. Then
load paper and
resend the job.
The rear cover
Replace the rear
has been
cover.
removed.
Printer cannot
If you are using cut
detect paper.
sheets, make sure
the paper is flat.
Move the paper
lever.
PAPER NOT CUT
Reload paper.
error was
cleared.
Manually loaded
Insert the sheet
sheet is not
further into the
inserted far
printer.
enough.
Paper is too thick
Pull the paper lever
for head
out to remove the
cleaning.
paper. Head
cleaning
automatically starts.
After cleaning,
reload paper.
Printer could not
Remove the print.
feed the printer
page.
Message/
Light
Light
SERVICE REQ.
All lights
flashing
SET INK CRTG
—
SET PAPER
Paper
LEVER
light on
TOP COVER
—
OPEN
UNABLE TO
—
PRINT
WRONG INK
B Ink light
CARTRIDGE
on
WRONG
Paper
PAPER SIZE
light
flashing
4/04
Explanation
Response
The print head is
Pull out the green
locked.
tab to unlock the
print head.
An error has
Note the error
occurred.
number, then turn
the printer off and
back on. If the
message remains,
contact Epson.
Ink cartridge chip
Remove and
error.
reinstall the ink
cartridge. If the
message remains,
replace the ink
cartridge.
Paper lever was
Pull the lever all the
released during
way forward, to the
the printing
secured position.
process or
Start printing again
another
from the beginning
operation.
for best results.
Top cover is
Close the top cover.
open.
You tried to print
Press the
while an error
button to exit the
condition was
SelecType menu
present.
system. If the
message appears
again, clear the error
before you print.
You tried to
If you are installing
install the wrong
ink cartridges for the
ink cartridge.
first time, you must
install the cartridges
that came with your
printer.
If you are replacing
ink cartridges, check
the package and
product code. You
must use the ink
cartrdiges designed
for your printer.
Other cartridges will
not work.
Loaded paper
Make sure the size
does not match
you selected in the
the image size.
printer driver
matches the loaded
paper size. Load the
correct size paper if
necessary.
Pause
Drukuj stronę