Cisco Profile Series Instrukcja instalacji - Strona 13

Przeglądaj online lub pobierz pdf Instrukcja instalacji dla System konferencyjny Cisco Profile Series. Cisco Profile Series 44 stron. Jbod on the 12g sas modular raid controller
Również dla Cisco Profile Series: Podręcznik dla początkujących (41 strony), Podręcznik użytkownika (44 strony), Podręcznik użytkownika (7 strony), Podręcznik dla początkujących (35 strony), Skrócona instrukcja obsługi (2 strony), Podręcznik konfiguracji (13 strony), Arkusz instalacyjny (2 strony), Instrukcja instalacji (2 strony), Skrócona instrukcja obsługi (4 strony), Skrócona instrukcja obsługi (4 strony), Instrukcja instalacji (16 strony), Podręcznik dla początkujących (32 strony), Podręcznik (16 strony), Podręcznik dla początkujących (42 strony), Podręcznik dla początkujących (46 strony)

Drukuj stronę
Cisco Profile Series Instrukcja instalacji
Warning
If the symbol of suitability with an overlaid cross appears above a port, you must not connect the port
to a public network that follows the European Union standards. Connecting the port to this type of
public network can cause severe personal injury or can damage the unit. Statement 1031
Connect the unit only to DC power source that complies with the safety extra-low voltage (SELV)
Warning
requirements in IEC 60950 based safety standards. Statement 1033
Warning
Do not use this product near water; for example, near a bath tub, wash bowl, kitchen sink or laundry
tub, in a wet basement, or near a swimming pool. Statement 1035
Never install telephone jacks in wet locations unless the jack is specifically designed for wet
Warning
locations. Statement 1036
Never touch uninsulated telephone wires or terminals unless the telephone line has been
Warning
disconnected at the network interface. Statement 1037
Warning
Avoid using a telephone (other than a cordless type) during an electrical storm. There may be a remote
risk of electric shock from lightning. Statement 1038
When installing or replacing the unit, the ground connection must always be made first and
Warning
disconnected last. Statement 1046
Do not locate the antenna near overhead power lines or other electric light or power circuits, or
Warning
where it can come into contact with such circuits. When installing the antenna, take extreme care
not to come into contact with such circuits, because they may cause serious injury or death. For
proper installation and grounding of the antenna, please refer to national and local codes (for
example, U.S.:NFPA 70, National Electrical Code, Article 810, Canada: Canadian Electrical Code,
Section 54). Statement 1052
Warning
No user-serviceable parts inside. Do not open. Statement 1073
Installation of the equipment must comply with local and national electrical codes. Statement 1074
Warning
Only trained and qualified personnel should be allowed to install, replace, or service this equipment.
Warning
Statement 1030
Cisco 800M Series Integrated Services Router Hardware Installation Guide
xv