Cisco 7513 Series Podręcznik - Strona 22

Przeglądaj online lub pobierz pdf Podręcznik dla Serwer Cisco 7513 Series. Cisco 7513 Series 30 stron. Chassis replacement
Również dla Cisco 7513 Series: Skrócona instrukcja obsługi (44 strony), Instrukcja wymiany (26 strony), Arkusz danych (11 strony), Utrzymanie (20 strony), Instrukcja wymiany (19 strony), Instrukcja wymiany (22 strony)

Replacing or Upgrading the Chassis

Step 7

Step 8

Step 9

Step 10

Step 11

Figure 10

Note

This completes the processor module removal and replacement procedure. If you need to install the

new chassis in an equipment rack, proceed to the "Installing the New Chassis in the Rack" section

on page 15. Otherwise, proceed to the next section to check the installation.

22 Cisco 7513 and Cisco 7576 Chassis Replacement and Upgrade Instructions

Place the processor module in the same slot position in the new chassis and align the

notches along the edge of the carrier with the grooves in the slot. (See Figure 9a.)

While keeping the carrier at a 90-degree orientation to the backplane, carefully slide the

carrier into the slot until the back of the faceplate makes contact with the ejector levers,

and then stop. (See Figure 9b.)

Do not use unnecessary force when installing processor modules. Always guide the

carrier into the slot only until the carrier faceplate makes contact with the ejector levers;

then use the ejector levers to complete the insertion.

Using the thumb and foreﬁnger of each hand to pinch each ejector, simultaneously push

both ejectors inward (toward the carrier handle) until they snap into place and are at a full

90-degree orientation to the faceplate. (See Figure 9c.) The carrier ears (the ends of the

faceplate) should be ﬂush against the chassis.

Use a screwdriver to tighten the two captive screws to prevent the processor module from

becoming partially dislodged from the backplane and to ensure proper EMI shielding.

Repeat Steps 2 through 10 for the remaining interface processors.

Handling a Processor Module

Leave the interface processor ﬁller installed in any unﬁlled interface processor slots.