Cisco MC2000 Podręcznik dla początkujących - Strona 33
Przeglądaj online lub pobierz pdf Podręcznik dla początkujących dla Serwer Cisco MC2000. Cisco MC2000 42 stron. Firepower management center
Również dla Cisco MC2000: Instrukcja obsługi (20 strony)
Drukuj stronę
Note:
If you are restoring an appliance to the same major version, or if this is your second pass through the
process, skip to the next procedure:
To perform the first pass of a two-pass restore process:
1.
From the restore utility main menu, select
2.
When prompted (twice), confirm that you want to reboot the appliance.
3.
Monitor the reboot and invoke the restore process again:
If the system is performing a database check, you may see the following message:
The system is not operational yet. Checking and repairing database are in progress.
This may take a long time to finish.
For a keyboard and monitor connection, quickly press one of the arrow keys to prevent the appliance from
booting the currently installed version of the system.
For a serial or SOL/LOM connection, when you see the BIOS boot options, press Tab slowly and repeatedly
until the LILO boot prompt appears. For example:
GNU/Linux - LILO 24 - Boot Menu
6.1.0
System_Restore
Restore_Serial
4.
Indicate that you want to restore the system:
—
For a keyboard and monitor connection, use the arrow keys to select System_Restore and press Enter.
—
For a serial or SOL/LOM connection, type Restore_Serial at the prompt and press Enter.
In either case, the boot prompt appears after the following choices:
0. Load with standard console
1. Load with serial console
5.
Select a display mode for the restore utility's interactive menu:
—
For a keyboard and monitor connection, type
—
For a serial or SOL/LOM connection, type
If you do not select a display mode, the restore utility defaults to the standard console after 30 seconds.
Unless this is the first time you have restored the appliance to this major version, the utility automatically loads
the last restore configuration you used. To continue, confirm the settings in a series of pages.
6.
Press Enter to confirm the copyright notice.
What to do Next
Begin the second pass of the process, starting with
page
28.
Second or Only Pass
Use the following procedure to perform the second or only pass through the restore process.
To perform the second or only pass through the restore process:
1.
If you are performing the second pass of a two-pass restore process, download and mount the ISO image
again, as described in
2.
From the restore utility main menu, select
Cisco Firepower Management Center Getting Started Guide
Second or Only Pass, page
5 Run the Install
1
Downloading the ISO and Update Files and Mounting the Image, page
5 Run the Install
Restoring a Firepower Management Center to Factory Defaults
33.
.
and press Enter.
0
and press Enter.
Using the Interactive Menu to Restore an Appliance,
.
32.
33