Cisco ONS 15454 Instrukcja instalacji - Strona 12
Przeglądaj online lub pobierz pdf Instrukcja instalacji dla Serwer Cisco ONS 15454. Cisco ONS 15454 22 stron. Four-shelf and zero-shelf bay assembly
Również dla Cisco ONS 15454: Instalacja (32 strony), Instalacja (32 strony), Rozpakowywanie i instalacja (42 strony), Rozpakowywanie i instalacja (40 strony)
Drukuj stronę
NTP- A246 Install Ethernet Cards and Connectors
Class I (CDRH) and Class 1M (IEC) laser products. Statement 1055
Warning
Invisible laser radiation could be emitted from the end of the unterminated fiber cable or connector.
Warning
Do not stare into the beam directly with optical instruments. Viewing the laser output with certain
optical instruments (for example, eye loupes, magnifiers, and microscopes) within a distance of
100 mm could pose an eye hazard. Statement 1056
Use of controls, adjustments, or performing procedures other than those specified may result in
Warning
hazardous radiation exposure. Statement 1057
Warning
To comply with the Telcordia GR-1089 Network Equipment Building Systems (NEBS) standard for
electromagnetic compatibility and safety, connect the copper Ethernet ports to intrabuilding or
nonexposed wiring and cabling only.
Always use the supplied ESD wristband when working with a powered ONS 15454. Plug the wristband
Caution
cable into the ESD jack located on the lower-right outside edge of the shelf assembly.
If protective clips are installed on the backplane connectors of the cards, remove the clips before
Note
installing the cards.
If you are installing OC-N, TXP, or MXP cards, Cisco recommends that you install these before you
Note
install Ethernet cards.
If you installed XC or XCVT cards, review
Step 1
If you installed XC10G or XC-VXC-10G cards, review
compatibility.
Step 2
Complete the
before installing the next card.
Note
Complete the
Step 3
E1000-2, E1000-2-G, ML1000-2, ML100X-8, or CE-1000-4 cards.
Note
Continue with the
Step 4
Cisco ONS 15454 Procedure Guide, R8.0
2-12
"DLP-A39 Install Ethernet Cards" task on page
If you install the wrong card in a slot, complete the
procedure on page
2-20.
"DLP-A469 Install a GBIC or SFP/XFP Device" task on page 21-57
If you need to remove a GBIC or SFP/XFP, complete the
SFP/XFP Devices" task on page
"NTP-A274 Install the FC_MR-4 Card" procedure on page 2-13
Chapter 2 Install Cards and Fiber-Optic Cable
Table 2-1 on page 2-3
to determine card/slot compatibility.
Table 2-2 on page 2-5
17-42. Allow each card to boot completely
"NTP-A116 Remove and Replace a Card"
"DLP-A470 Remove GBIC or
21-59.
to determine card/slot
if you are using
as needed.
78-17697-01