Epson ES-300C Biuletyn wsparcia produktu - Strona 14

Przeglądaj online lub pobierz pdf Biuletyn wsparcia produktu dla Skaner Epson ES-300C. Epson ES-300C 19 stron. Laser & non-impact printer error codes
Również dla Epson ES-300C: Podręcznik (8 strony), Podręcznik uzupełniający (15 strony), Podręcznik (11 strony), Biuletyn wsparcia produktu (20 strony), Biuletyn wsparcia produktu (14 strony), Biuletyn wsparcia produktu (25 strony), Biuletyn wsparcia produktu (13 strony)

EPL-7000 cont.

[E] REMOVE CARD

You may have inserted a font card or cartridge while the printer was on line or

while the FEED light was on. Data still remains in the printer's buffer.

[E] RESELECT TRAY

The optional lower paper cassette is not installed and the INPUT option is set

to OPT or AUTO.

[S] RESET

The printer is being reset to the previous settings in the macro specified with

LOAD MACRO option in SelecType Level 1.

[S] ROM Check

The printer is checking ROM.

[E] SAVE MEMORY OVERFLOW

lf this message appears when you are trying to save a macro with the SAVE

MACRO option in SelecType Level 1, the printer does not have enough

memory to save any additional macros

[E] SERVICE REQ. CXXX

A controller error has been detected.

[E] SERVICE REQ. EOOXX

A print engine error has been detected.

XX= 03 Fusing Unit (low temp)

[E] SET FULL PRINT

This message may appear when you are trying to print graphics or a mix of

text and graphics.

[S] STANDBY MODE

When both CH P and CH S remain off for about thirty minutes, the printer

enters standby mode and this message appears.

[E] STARTUP ERROR

lf this message appears when you turn on the printer, the power may have

been turned off while the printer was performing a save or reset operation.

04 Main Drive Motor

05 Ozone Fan motor

06 Polygon Mirror Drive

09 HSync Signal

PSB No: P-0077

Page: 6 of 11