Cisco UCS B200 M3 Instrukcja instalacji - Strona 29

Przeglądaj online lub pobierz pdf Instrukcja instalacji dla Serwer Cisco UCS B200 M3. Cisco UCS B200 M3 34 stron. Blade server
Również dla Cisco UCS B200 M3: Uwaga dotycząca instalacji i obsługi (36 strony), Uwaga dotycząca instalacji i obsługi (37 strony), Podręcznik (8 strony), Instrukcja aktualizacji (21 strony), Uwaga dotycząca instalacji i obsługi (28 strony)

Installing an Adapter Card

The network adapters and interface cards all have a shared installation process and are constantly being updated. A list of currently

supported and available models for this server is in the specification sheets at this URL:

http://www.cisco.com/en/US/products/ps10280/products_data_sheets_list.html

If a VIC 1240 mLOM is not installed, you must have an adapter card installed.

Note

Use of the adapters available for this server might require an upgrade to the FEX in the chassis. The

Note

2104XP FEX is not compatible with any Cisco-certified adapter. If a VIC 1240 mLOM card is installed,

you will have connectivity through the mLOM but other adapters will not be recognized. Use of all slots

requires Cisco UCS 2200 series FEXes.

If you are switching from one type of adapter card to another, before you physically perform the switch make sure that you download

the latest device drivers and load them into the server's operating system. For more information, see the firmware management chapter

of one of the Cisco UCS Manager software configuration guides.

The Cisco UCS 785GB or 365GB MLC Fusion-io Drive and LSI 400GB SLC WarpDrive have the same form factor as M3 adapter

cards and can be installed and removed using the same procedures. Using these drives in a B200 M3 or B22 M3 blade server requires

the presence of a VIC 1240 mLOM to provide blade I/O. They will not work in M1 and M2 generation Cisco UCS servers. These

drives appear in Cisco UCS Manager as regular SSDs.

Procedure

Step 1

Position the adapter board connector above the motherboard connector and align the two adapter captive screws to the

standoff posts (see callout 1) on the motherboard.

Step 2

Firmly press the adapter connector into the motherboard connector (see callout 2).

Step 3

Tighten the two captive screws (see callout 3).