Epson Stylus Photo RX600 Informacje o produkcie - Strona 14

Przeglądaj online lub pobierz pdf Informacje o produkcie dla Skaner Epson Stylus Photo RX600. Epson Stylus Photo RX600 19 stron. Product support bulletin(s)
Również dla Epson Stylus Photo RX600: Wskazówki (2 strony), Karta informacyjna produktu (4 strony), Broszura (2 strony), Instrukcja konfiguracji (2 strony), Podręcznik Start Here (10 strony), Skrócona instrukcja obsługi (28 strony), Podręcznik użytkownika (12 strony), Aktualizacja (1 strony), Biuletyn wsparcia produktu (6 strony), Biuletyn wsparcia produktu (1 strony), Specyfikacje (2 strony), Jak kopiować i drukować (20 strony), Instrukcja obsługi (4 strony)

Drukuj stronę

Epson Stylus Photo RX600

Placing 35 mm Slides on the Film Holder

1. Position the film holder so that the 35 mm slide section

faces the center of the scanner glass. The positioning posts

fit in two small holes near the scanner lid, as shown.

2. Places slides in the film holder as shown, with the duller

(emulsion) side facing up.

Make sure the top of

images with portrait

orientation face the

front of the RX600

Note:

If your slide image is in landscape orientation (wider than it is

long), place it in the same direction as slide images in portrait

orientation (longer than they are wide). This copies the maximum

image area, but your preview will be rotated.

3. Close the scanner lid.

Now you are ready copy, print, or scan. See the User's Guide

for instructions.

Epson Stylus Photo RX600

14 -

Cleaning the Print Head

If your printouts are unexpectedly light, or dots or lines are

missing, you may need to clean the print head. This unclogs

the nozzles so they can deliver ink properly. Print head

cleaning uses ink, so clean it only if quality declines.

Note:

You can also clean the print head using the printer software. Click the

? or Help button on your printer settings window for instructions on

running the print head cleaning utility.

1. Make sure the RX600 is turned on but not printing, and the

error light is off. (If the

may need to replace an ink cartridge; see page 15 for

details.)

2. Press the

button to enter setup mode.

Setup

3. Press the u and d buttons to select

4. Press the

button, then press

print head.

Cleaning takes about 30 seconds, during which the message

appears on the LCD screen.

Head Cleaning

Caution:

Never turn off the RX600 while the message Head Cleaning

appears on the LCD screen, unless the RX600 hasn't moved or

made noise for more than 5 minutes.

5. When head cleaning is finished, you return to the Setup

Menu. Use the u and d buttons to select

6. Make sure letter-size paper is loaded. Press the

then press

to print a nozzle check.

Note:

You can also print a nozzle check using the printer software. Click

the ? or Help button on your printer settings window for

instructions on printing a nozzle check.

7. Examine the nozzle check pattern you printed. Each

staggered line should be solid, with no gaps, as shown.

If your printout looks okay, you're done. Click

to return to the main menu.

If you see any gaps (as shown below) in the dot pattern,

press

. Then follow the instructions on the LCD

screen to clean the print head again.

2/04

error light is flashing or on, you

Head cleaning

to start cleaning the

Nozzle Check

button,

Cancel