Motorola C25 Instrukcja serwisowa - Strona 41
Przeglądaj online lub pobierz pdf Instrukcja serwisowa dla Telefon bezprzewodowy Motorola C25. Motorola C25 50 stron. Dual band wireless telephone
Drukuj stronęLevel 1 and 2 Service Manual
Table 3. PF C25 and C43 Telephones: Level 1 and 2 Troubleshooting Chart (Continued)
SYMPTOM
7. Telephone will not recognize or accept
SIM card.
8. Vibrator feature not functioning.
9. Internal Charger not working.
10. No or weak audio when using headset. a) Headset plug not fully inserted.
6881039B15
PROBABLE CAUSE
b) Transceiver board assembly
defective.
a) SIM card defective.
b) Transceiver board assembly
defective.
a) Vibrator defective.
b) Transceiver board assembly
defective.
Faulty charger circuit on transceiver
board assembly.
b) Faulty jack on transceiver board
assembly.
August 01, 2001
VERIFICATION AND REMEDY
Replace the transceiver board assembly (refer
to 1c). Verify that the fault has been cleared and
reassemble with the new transceiver board
assembly.
Check the SIM card contacts for dirt. Clean if
necessary, and check if fault has been cleared.
If the contacts are clean, insert a known good
SIM card into the telephone. Power up the unit
and confirm that the card has been accepted. If
the fault no longer exists, replace the defective
SIM card. If the SIM card is not at fault, proceed
to b.
Replace the transceiver board assembly (refer
to 1c). Verify that the fault has been cleared and
reassemble the unit with the new transceiver
board assembly.
Replace vibrator as described in the
procedures. If the fault has not been cleared,
proceed to b.
Replace the transceiver board assembly (refer
to 1c). Verify that the fault has been cleared and
reassemble the unit with the new transceiver
board assembly.
insert a known good discharged battery.
Connect a known good charger and verify
battery is being charged. If fault still present,
replace the transceiver board assembly (refer to
1c). Verify that the fault has been cleared and
reassemble the unit with the new transceiver
board assembly.
Ensure the headset plug is fully seated in the
jack.
Replace the transceiver board assembly (refer
to 1c). Verify that the fault has been cleared and
reassemble the unit with the new transceiver
board assembly.
Troubleshooting
37