Motorola Radius CM200 Instrukcja instalacji - Strona 17

Przeglądaj online lub pobierz pdf Instrukcja instalacji dla Radio Motorola Radius CM200. Motorola Radius CM200 36 stron. Commercial series

Antenna Installation

Mounting restrictions for certain radio models

For 40 Watt UHF models, the 1/4 wave antenna should be mounted only in the center area of

the roof, not on the trunk lid, to assure compliance with RF Energy Safety standards.

5. Ensure that the antenna cable can be easily routed to the radio. Route the antenna cable as far

away as possible from any vehicle electronic control units and associated wiring.

6. Check the antenna location for any electrical interference.

7. Make sure any other mobile radio antenna on this vehicle is at least 30.48cm (1 foot) away from

this antenna.

NOTE Any two metal pieces rubbing against each other (such as seat springs, shift levers,

trunk and hood lids, exhaust pipes, etc.) in close proximity to the antenna can cause

severe receiver interference.

4.3

Antenna Installation Procedure

1. Mount the antenna according to the instructions provided with the antenna kit. Run the coaxial

cable to the radio mounting location. If necessary, cut off the excess cable and install the cable

connector.

2. Connect the antenna cable connector to the radio antenna connector on the rear of the radio.

(See Figure 4-1.)

Antenna

Connector

4.4

1. Mount the microphone clip to a convenient spot near your radio.

2. Your microphone has a telephone-type connector at the end of its cord. Plug the microphone into

the control head connector.

3. To complete your radio installation, plug the power cable into the radio power connector. (See

Figure 4-1.)

Figure 4-1. Connections to the Back of Radio

Accessory

Connector

Housing

Power

Connector