Acumen Scooter Instrukcja instalacji i obsługi - Strona 3

Przeglądaj online lub pobierz pdf Instrukcja instalacji i obsługi dla Alarm samochodowy Acumen Scooter. Acumen Scooter 8 stron. Arkon work light user manual

Drukuj stronę

Installation and Wiring

Connect the system wires as

follows:

A larger version of the wiring diagram

can be found on the back page.

The R R E E D D wire is the alarm positive feed.

DO NOT connect this directly to the

scooter battery, but connect to the

positive terminal of the starter solenoid.

Use the Red-tagged ring terminal from

the fit kit.

The B B L L A A C C K K wire is the alarm negative

connection. Connect this wire to a

suitable earthing point on the scooter

frame. DO NOT connect to the battery

negative terminal. Do NOT connect it to a

sub-frame or fairing-frame. An ideal spot

is the connection of the scooter battery

negative lead & frame. Use the Blue-

tagged ring terminal from the fit kit.

The B B R R O O W W N N wire should be connected

to a circuit which becomes live when the

ignition is switched on. Ideally, this

should be connected between the

ignition switch and the scooter fuse box.

If this is not practical, a good place is the

feed to the rear brake light switch.

Acumen recommends this connection is

soldered.

C C o o n n n n e e c c t t t t h h e e 6 6 - - w w a a y y c c o o n n n n e e c c t t o o r r s s t t o o g g e e t t h h e e r r

a a n n d d p p r r o o c c e e e e d d t t o o O O p p e e r r a a t t i i o o n n

To make the alarm active, you only need to connect the

T T o o g g e e t t f f u u l l l l b b a a s s i i c c o o p p e e r r a a t t i i o o n n o o f f t t h h e e S S C C O O O O T T E E R R S S y y s s t t e e m m , , A A c c u u m m e e n n r r e e c c o o m m m m e e n n d d s s

t t h h a a t t y y o o u u a a l l s s o o c c o o n n n n e e c c t t t t h h e e P P I I N N K K ( ( i i n n d d i i c c a a t t o o r r s s ) ) a a n n d d B B l l a a c c k k / / R R e e d d ( ( L L E E D D ) ) w w i i r r e e s s ( ( s s e e e e p p a a g g e e 3 3 ) )

Should you require further options on the CAT 3 system, please see the Optional Wiring (see page 3)

R R e e d d , , B B l l a a c c k k and B B r r o o w w n n wires