Ariel Whirlpool BT series Podręcznik użytkownika - Strona 4

Przeglądaj online lub pobierz pdf Podręcznik użytkownika dla Wanny Ariel Whirlpool BT series. Ariel Whirlpool BT series 10 stron.

Drukuj stronę
User manual whirlpool D-series with Bluetooth

After installation:

1.
Before starting up the product for the 1
connected. Recommended control points are water fittings and pipes on the faucet to the various functions.
2.
Before starting up the product for the 1
3.
After installation check that the whirlpool is clean. We recommend to clean the whirlpool first before you add water to it. Any
dirt can clog the pipes and massage jets. If the bath is clean, close the drain of the tub and fill the tub with water up to the sensor.
The sensor for this is placed just above the level of the highest jets. If the water is below the sensor, the pump will not work for safety
reasons.
4.
Switch the system on and operate for a minimum period of 10 min. Without draining down, switch the whirlpool system off
and after a minimum period of 10 min check all pipework, joints and connections for possible leaks. After any necessary adjustment to
ensure the integrity of the installation or the replacement of any faulty elements, repeat the procedure.
5.
You must ensure that the product works as expected. Test all functions of the product to immediately check and correct any
errors. After testing, put the bath in place and seal the wall joints with acid-free plumbing kit. Let it harden sufficiently.
Important note:
In general, the use of strong bath oils in whirlpools is against advise. Oil remains can stick on the inside of the hose system and can cause
troubles in due time. If you do want these kind of products, use oils specific for whirlpools.

The display:

Power supply
Colour changing lights
Channel memory
Air pump
Constant temperature
Brightness function
Parameter setting
Water pump
st
time you have to go over all connections to control that they are well
st
time you have to check if all electrical wires are connected correctly.
Music
Parameter setting up
Parameter setting down
Page 4 / 9