Arisco BW800 Instrukcja obsługi - Strona 14

Przeglądaj online lub pobierz pdf Instrukcja obsługi dla Spryskiwacz Arisco BW800. Arisco BW800 19 stron. Glass washing machine

Fix all parts in their place in such a way conforming to their original conditions.

Close the cover of the device.

Open the relevant switch on the control panel supplying electric to the device. Bring the "STAND BY and "START"

switchs into starting position.

For complete cleaning of the device, run the device for 5 minutes

Bring the "START" switch into" pause" position.

Open the cover.

WEEKLY MAINTANCE

When the water in washing tank gets dirty, it must be replaced by fresh water.

For this propose, bring the STAND BY and START swatches of the machine into "stop" and close the device.

Closing the switch, switch the electricity off.

After opening the cover, be careful of not impacting the cover holder.

Take out the overflow pipe.

Remove the washing and rinsing buttery nozzles and clean them. Wash the rinsing nozzles and rinse them.

Taking out the surface filters and pump suction filters, clean them by brush under the flowing water.

Fix all parts in their place in such a way conforming to their original conditions.

Close the cover of the device.

Open the relevant switch on the control panel supplying electric to the device. Bring the "STAND BY and "START"

switchs into starting position.

For complete cleaning of the device, run the device for 5 minutes

Bring the "START" switch into" pause" position.

Open the cover.

13. SAFE LIFE

The safe life of the product is 5 years.

FAILURES / CAUSES

• Device is not working

• Check whether there is electric supply to the device.

• Be sure that there is electric supply to the stand by and start switchs

• Be sure that electric supply to level switch and solenoid valve.

• There is no being filled:

• Check the level switch.

• Check whether there are any contaminants in the tube in washing tank

• Be sure that there is adequate level of water in washing tank.

• Check the solenoid valve opens and closes. Open and close the switch. If it does not work, change by new ones.

• Washing tank is mot being filled or there is no rinsing:

• Be sure that the tap supplying water is open

• Check whether drainage pipe is fixed in its place or not.

• Be sure that stand by and start switchs are open.

• Be sure that main fuse supplying the machine is in active.

• Check the fuse of machine.

• Be sure that there is no plugging in buttery nozzles due to contaminants.

• Be sure that sufficient amount of air in air housing

14 / 19