Xerox Phaser 8200 Instrukcja konfiguracji sieci - Strona 36

Przeglądaj online lub pobierz pdf Instrukcja konfiguracji sieci dla Akcesoria do drukarek Xerox Phaser 8200. Xerox Phaser 8200 47 stron. Phaser color printer
Również dla Xerox Phaser 8200: Instrukcja instalacji modułu tacki (2 strony), Instrukcja instalacji (2 strony), Instrukcja instalacji (1 strony), Podręcznik szybkiego uwalniania (1 strony), Instalacja (1 strony), Podręcznik (2 strony), Specyfikacje (4 strony), Instrukcja serwisowa (11 strony)

Xerox Phaser  8200 Instrukcja konfiguracji sieci

Macintosh troubleshooting (MacOS 8.x/9.x/10.1)

The steps in this procedure should eliminate cabling, communication, and connection problems.
Complete these steps, then run a test print from your software application. If the job prints, no further
system troubleshooting is necessary. For print quality problems, see Troubleshooting in the Phaser
8200 Color Printer User Guide on the Software and Documentation CD-ROM.
Macintosh troubleshooting step-by-step
Perform Steps 1 and 2 if you are using Mac OS 8.x or 9.x.
1.
Start the Chooser in Operating System 8 or greater software and select the LaserWriter driver.
2.
If the printer name appears, your printer is communicating through the network. You do not need
to perform any of the checks outlined in this section. If your printer name does not appear, proceed
to Step 3.
3.
Verify that the printer is plugged in, turned on, and connected to an active network.
4.
Verify cable connection to the printer from the network.
5.
For AppleTalk, follow the steps below. For TCP/IP (MacOS X, version 10.1 only), continue to
Step 6.
a.
From the printer's front panel, verify that EtherTalk is enabled. If not, enable it in the front
panel and reset the printer.
b.
Print the Configuration Pages and verify that EtherTalk is enabled.
c.
From the Configuration Pages, verify the Zone. If you have multiple zones on your network,
be certain your printer appears in the desired zone.
Perform Step 6 only if you are using MacOS X, version 10.1.
6.
For TCP/IP, follow the steps below.
a.
Open the Network Utility and select the Ping tab.
b.
Enter your printer's IP address.
c.
Click Ping. If you do NOT get a response, confirm that your TCP/IP settings are correct for
both your printer and Macintosh.
7.
If you are still unable to print, refer to the Xerox web site at
support
or access PhaserSMART through CentreWare Internet Services. From a web browser,
enter your printer's IP address. Select Support. Select the Technical Support link to access
PhaserSMART.
Phaser® 8200 Color Printer
Macintosh EtherTalk Network (MacOS 8.x/9.x/X, version 10.1)
www.xerox.com/officeprinting/
31