Yamaha AvantGard N1 Instrukcja obsługi - Strona 42

Przeglądaj online lub pobierz pdf Instrukcja obsługi dla Instrument muzyczny Yamaha AvantGard N1. Yamaha AvantGard N1 50 stron. Hybrid piano
Również dla Yamaha AvantGard N1: Podręcznik konserwacji (45 strony)

Drukuj stronę

1. IMPORTANT NOTICE: DO NOT MODIFY THIS

UNIT!

This product, when installed as indicated in the instruc-

tions contained in this manual, meets FCC requirements.

Modifications not expressly approved by Yamaha may

void your authority, granted by the FCC, to use the prod-

uct.

2. IMPORTANT:

When connecting this product to acces-

sories and/or another product use only high quality

shielded cables. Cable/s supplied with this product

MUST be used. Follow all installation instructions. Failure

to follow instructions could void your FCC authorization

to use this product in the USA.

3. NOTE:

This product has been tested and found to com-

ply with the requirements listed in FCC Regulations, Part

15 for Class "B" digital devices. Compliance with these

requirements provides a reasonable level of assurance

that your use of this product in a residential environment

will not result in harmful interference with other electronic

devices. This equipment generates/uses radio frequen-

cies and, if not installed and used according to the

instructions found in the users manual, may cause inter-

ference harmful to the operation of other electronic

* This applies only to products distributed by YAMAHA CORPORATION OF AMERICA.

42 • N1

Owner's Manual

FCC INFORMATION (U.S.A.)

devices. Compliance with FCC regulations does not

guarantee that interference will not occur in all installa-

tions. If this product is found to be the source of interfer-

ence, which can be determined by turning the unit "OFF"

and "ON", please try to eliminate the problem by using

one of the following measures:

Relocate either this product or the device that is being

affected by the interference.

Utilize power outlets that are on different branch (circuit

breaker or fuse) circuits or install AC line filter/s.

In the case of radio or TV interference, relocate/reorient

the antenna. If the antenna lead-in is 300 ohm ribbon

lead, change the lead-in to co-axial type cable.

If these corrective measures do not produce satisfactory

results, please contact the local retailer authorized to dis-

tribute this type of product. If you can not locate the

appropriate retailer, please contact Yamaha Corporation

of America, Electronic Service Division, 6600 Orangetho-

rpe Ave, Buena Park, CA90620

The above statements apply ONLY to those products dis-

tributed by Yamaha Corporation of America or its subsid-

iaries.

(class B)