Zanussi ZI 457 Instrukcja obsługi - Strona 17
Przeglądaj online lub pobierz pdf Instrukcja obsługi dla Zmywarka Zanussi ZI 457. Zanussi ZI 457 19 stron.
Drukuj stronę
BUILDING-IN
Building-in features
This dishwasher is designed to be fitted under a kitchen
counter or sink.
In either case, it is essential that the recess dimensions
indicated in the picture are followed.
No further openings for venting of the dishwasher are
required, but only to let the water fill and drain hoses
and power supply cable pass through.
II24
II06
The recess height may be anywhere between 820
and 880 mm from the floor since the dishwasher
incorporates levelling feet adjustable over a wide
range (max 60 mm).
Adjust the height of the appliance by turning these
feet.
A distance of 2 mm should be allowed between the
top of the dishwasher and the counter top.
Fitting under a counter (kitchen worktop
or sink)
It is absolutely essential that the dishwasher is
disconnected from the electricity supply before gaining
access to any internal component.
Fit the dishwasher into the appropriate housing space
and connect it. Make sure that the water fill and drain
hoses and the power supply cable are not bent or
kinked.
Fitting the panel onto the door
The door on this model is designed for the overlay of
a panel having the following dimensions:
Width:
446 mm
Height:
644 to 714 mm max
Thickness:
20 mm max
Weight:
1.5 to 6 kg max
Note:
The panel height should not be more than what
indicated, otherwise complete opening of the door will
no longer be possible as the panel hits against the
dishwasher plinth.
Mounting of decor panel onto the door
The height of the panel depends on the height of the
plinth of adjacent kitchen units (see kitchen plinth
adjustment).
446 max
360
*
*
II27
Fix the cross bar onto the panel using four 3.5x16
screws provided. Reduce the length of fixing screws
according to thickness of panel.
If for aesthetic matching the panel is provided with a
false drawer (fitted or carved on the panel itself), the
two brackets provided should also be used.
446 max
=
=
391,5
II26
Reduce the length of fixing screws according to
thickness of panel.
II12
II10
PII05GB
34
The panel must be fitted
with a handle, as the dish-
washer handle will be hid-
den by the panel.
Drill the panel with a Ø
2x12 bit according to the
dimensions indicated in the
figure.
Fix the brackets according
to
the
measurements
shown in the figure, by us-
ing four 3.5 x 16 screws.
Mount the decor panel by
inserting the two pivots of
the cross-bar into the
slotted holes of the door.
Lift the decor panel until
perfect alignment with the
facia panel is obtained: if
the two brackets have also
been used, they will auto-
matically enagage in the
special holes provided on
the dishwasher door.
Once the correct position
has been found, open the
door and fasten the decor
panel on the lower section
by means of the two long
4x40 screws provided,
using the holes through the
inner door (see fig.).