Zanussi ZSF2430 Podręcznik użytkownika - Strona 7

Przeglądaj online lub pobierz pdf Podręcznik użytkownika dla Zmywarka Zanussi ZSF2430. Zanussi ZSF2430 16 stron.
Również dla Zanussi ZSF2430: Podręcznik użytkownika (32 strony)

Drukuj stronę

Using the detergent

Fill the detergent dis-

penser (A) with deter-

gent.

Combi detergent tablets

These tablets contain detergent, rinse aid and

other added agents. Be sure that these tablets

are applicable to the water hardness in your

area. Refer to the instructions on the packaging

of the products.

When you use tablets, that contain salt and

rinse aid, do not fill the salt container and the

rinse aid dispenser.

1. Adjust the water softener to the lowest level.

www.zanussi.com

If you use a washing

programme with pre-

wash phase, put more

detergent in the pre-

wash detergent com-

partment (B).

2. Set the rinse aid dispenser to the lowest po-

sition.

If you stop to use the combi detergent

tablets, before you start to use separately

detergent, rinse aid and dishwasher salt,

do these steps:

1. Turn the programme knob until the pro-

gramme marker is aligned with the shortest

programme with a rinsing phase.

2. Set the water softener to the highest level.

3. Make sure that the salt container and the

rinse aid dispenser are full.

4. Start the set programme, without detergent

and without dishes.

5. Adjust the water softener to the water hard-

ness in your area.

6. Adjust the released quantity of rinse aid.

Setting and starting a programme

Setting mode

The appliance must be in setting mode to

start a programme.

• Turn the programme knob until the pro-

gramme marker is aligned with a programme

on the control panel. If the on/off indicator

comes on and the phase indicators for the

programme start to flash, the appliance is in

setting mode.

• Turn the programme knob until the pro-

gramme marker is aligned with a programme

on the control panel. If the on/off indicator

and the start indicator come on and a phase

indicator is on with fixed light, the appliance is

not in setting mode.

To put the appliance in setting mode, press and

hold the start button until the start indicator

goes off and the phase indicators for the pro-

gramme start to flash.

Starting a programme without delay start

1. Open the water tap.

2. Close the appliance door.

3. Turn the programme knob until the pro-

gramme marker is aligned with the pro-

gramme you want to set.

• The on/off indicator comes on.