Zanussi zft 710 w Podręcznik użytkownika - Strona 43
Przeglądaj online lub pobierz pdf Podręcznik użytkownika dla Zamrażarka Zanussi zft 710 w. Zanussi zft 710 w 48 stron.
Drukuj stronęTrouble shooting
During operation of the appliance some smaller but
annoying trouble can often occur, which does not
require calling a technician out. In the following chart
information is given about them to avoid unnecessary
charges on service.
We draw your attention that operation of appliance
goes with certain sounds (compressor- and circulating
sound). This is not trouble, but means normal opera-
tion.
Problem
The
appliance
does not cool suffi-
ciently
The appliance
cools too hard
The appliance
does not cool at all
The appliance is
noisy
Inasmuch as the advice does not lead to result, call
the nearest brand-mark service.
Possible cause
Thermostatic control is set too low.
Before freezing the appliance was not
precooled sufficiently.
Large-sized food was put in.
Too many foods to be frozen were put
in.
Warm foods were put in.
Door is not shut properly.
The thermostatic control is set too
high.
Plug is not connected to the mains
socket properly.
There is no voltage in the mains sock-
et.
Thermostatic control is in „0" position.
The appliance is not supported proper-
ly.
We draw it to your attention again that the appli-
ance operates discontinuously, so the stopping
of compressor does not mean being no-current. That
is why you must not touch the electrical parts of the
appliance before removing it from the mains socket.
Set higher position.
Pre-cool the appliance for enough time.
Cut up food.
Put fewer foods to be cooled.
Put foods max. at room temperature.
Check if the door is shut.
Set lower position.
Check if the connection is proper.
Check if there is voltage.
Check setting of thermostatic control.
Check if the appliance stands stable (all the
four feet should be on the floor).
Solution
43